Merge tag 'asoc-v5.4' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/sound into for-next

ASoC: Updates for v5.4

Quite a big update this time around, particularly in the core
where we've had a lot of cleanups from Morimoto-san - there's
not much functional change but quite a bit of modernization
going on.  We've also seen a lot of driver work, a lot of it
cleanups but also some particular drivers.

 - Lots and lots of cleanups from Morimoto-san and Yue Haibing.
 - Lots of cleanups and enhancements to the Freescale, sunxi dnd
   Intel rivers.
 - Initial Sound Open Firmware suppot for i.MX8.
 - Removal of w90x900 and nuc900 drivers as the platforms are
   being removed.
 - New support for Cirrus Logic CS47L15 and CS47L92, Freescale
   i.MX 7ULP and 8MQ, Meson G12A and NXP UDA1334

1 files changed, 8 insertions, 24 deletions

diff --git a/drivers/net/phy/at803x.c b/drivers/net/phy/at803x.c
index 222ccd9ecfce..6ad8b1c63c34 100644
--- a/drivers/net/phy/at803x.c
+++ b/drivers/net/phy/at803x.c
@@ -257,36 +257,20 @@ static int at803x_config_init(struct phy_device *phydev)
 	 *   after HW reset: RX delay enabled and TX delay disabled
 	 *   after SW reset: RX delay enabled, while TX delay retains the
 	 *   value before reset.
-	 *
-	 * So let's first disable the RX and TX delays in PHY and enable
-	 * them based on the mode selected (this also takes care of RGMII
-	 * mode where we expect delays to be disabled)
 	 */
-
-	ret = at803x_disable_rx_delay(phydev);
-	if (ret < 0)
-		return ret;
-	ret = at803x_disable_tx_delay(phydev);
-	if (ret < 0)
-		return ret;
-
 	if (phydev->interface == PHY_INTERFACE_MODE_RGMII_ID ||
-	    phydev->interface == PHY_INTERFACE_MODE_RGMII_RXID) {
-		/* If RGMII_ID or RGMII_RXID are specified enable RX delay,
-		 * otherwise keep it disabled
-		 */
+	    phydev->interface == PHY_INTERFACE_MODE_RGMII_RXID)
 		ret = at803x_enable_rx_delay(phydev);
-		if (ret < 0)
-			return ret;
-	}
+	else
+		ret = at803x_disable_rx_delay(phydev);
+	if (ret < 0)
+		return ret;
 
 	if (phydev->interface == PHY_INTERFACE_MODE_RGMII_ID ||
-	    phydev->interface == PHY_INTERFACE_MODE_RGMII_TXID) {
-		/* If RGMII_ID or RGMII_TXID are specified enable TX delay,
-		 * otherwise keep it disabled
-		 */
+	    phydev->interface == PHY_INTERFACE_MODE_RGMII_TXID)
 		ret = at803x_enable_tx_delay(phydev);
-	}
+	else
+		ret = at803x_disable_tx_delay(phydev);
 
 	return ret;
 }