diff options
Diffstat (limited to 'Documentation/devicetree/bindings/fieldbus')
-rw-r--r-- | Documentation/devicetree/bindings/fieldbus/arcx,anybus-controller.txt | 71 |
1 files changed, 0 insertions, 71 deletions
diff --git a/Documentation/devicetree/bindings/fieldbus/arcx,anybus-controller.txt b/Documentation/devicetree/bindings/fieldbus/arcx,anybus-controller.txt deleted file mode 100644 index b1f9474f36d5..000000000000 --- a/Documentation/devicetree/bindings/fieldbus/arcx,anybus-controller.txt +++ /dev/null @@ -1,71 +0,0 @@ -* Arcx Anybus-S controller - -This chip communicates with the SoC over a parallel bus. It is -expected that its Device Tree node is specified as the child of a node -corresponding to the parallel bus used for communication. - -Required properties: --------------------- - - - compatible : The following chip-specific string: - "arcx,anybus-controller" - - - reg : three areas: - index 0: bus memory area where the cpld registers are located. - index 1: bus memory area of the first host's dual-port ram. - index 2: bus memory area of the second host's dual-port ram. - - - reset-gpios : the GPIO pin connected to the reset line of the controller. - - - interrupts : two interrupts: - index 0: interrupt connected to the first host - index 1: interrupt connected to the second host - Generic interrupt client node bindings are described in - interrupt-controller/interrupts.txt - -Optional: use of subnodes -------------------------- - -The card connected to a host may need additional properties. These can be -specified in subnodes to the controller node. - -The subnodes are identified by the standard 'reg' property. Which information -exactly can be specified depends on the bindings for the function driver -for the subnode. - -Required controller node properties when using subnodes: -- #address-cells: should be one. -- #size-cells: should be zero. - -Required subnode properties: -- reg: Must contain the host index of the card this subnode describes: - <0> for the first host on the controller - <1> for the second host on the controller - Note that only a single card can be plugged into a host, so the host - index uniquely describes the card location. - -Example of usage: ------------------ - -This example places the bridge on top of the i.MX WEIM parallel bus, see: -Documentation/devicetree/bindings/bus/imx-weim.txt - -&weim { - controller@0,0 { - compatible = "arcx,anybus-controller"; - reg = <0 0 0x100>, <0 0x400000 0x800>, <1 0x400000 0x800>; - reset-gpios = <&gpio5 2 GPIO_ACTIVE_HIGH>; - interrupt-parent = <&gpio1>; - interrupts = <1 IRQ_TYPE_LEVEL_LOW>, <5 IRQ_TYPE_LEVEL_LOW>; - /* fsl,weim-cs-timing is a i.MX WEIM bus specific property */ - fsl,weim-cs-timing = <0x024400b1 0x00001010 0x20081100 - 0x00000000 0xa0000240 0x00000000>; - /* optional subnode for a card plugged into the first host */ - #address-cells = <1>; - #size-cells = <0>; - card@0 { - reg = <0>; - /* card specific properties go here */ - }; - }; -}; |