From fb59ee37cfe20d10d19568899d1458a58361246c Mon Sep 17 00:00:00 2001 From: Faiz Abbas Date: Wed, 19 Jun 2019 15:54:54 +0530 Subject: ARM: dts: am57xx: Disable voltage switching for SD card If UHS speed modes are enabled, a compatible SD card switches down to 1.8V during enumeration. If after this a software reboot/crash takes place and on-chip ROM tries to enumerate the SD card, the difference in IO voltages (host @ 3.3V and card @ 1.8V) may end up damaging the card. The fix for this is to have support for power cycling the card in hardware (with a PORz/soft-reset line causing a power cycle of the card). Because the beaglebone X15 (rev A,B and C), am57xx-idks and am57xx-evms don't have this capability, disable voltage switching for these boards. The major effect of this is that the maximum supported speed mode is now high speed(50 MHz) down from SDR104(200 MHz). commit 88a748419b84 ("ARM: dts: am57xx-idk: Remove support for voltage switching for SD card") did this only for idk boards. Do it for all affected boards. Signed-off-by: Faiz Abbas Signed-off-by: Tony Lindgren --- arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi | 1 + 1 file changed, 1 insertion(+) (limited to 'arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi') diff --git a/arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi b/arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi index 2341a56ebab9..0cdfd2853ba8 100644 --- a/arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi +++ b/arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi @@ -433,6 +433,7 @@ bus-width = <4>; cd-gpios = <&gpio6 27 GPIO_ACTIVE_LOW>; /* gpio 219 */ + no-1-8-v; }; &mmc2 { -- cgit v1.2.3 From 2e8647bbe1c8233a20c32fd2648258f2c05c7335 Mon Sep 17 00:00:00 2001 From: Tony Lindgren Date: Mon, 22 Jul 2019 03:44:47 -0700 Subject: ARM: dts: Fix flags for gpio7 The ti,no-idle-on-init and ti,no-reset-on-init flags need to be at the interconnect target module level for the modules that have it defined. Otherwise we get the following warnings: dts flag should be at module level for ti,no-idle-on-init dts flag should be at module level for ti,no-reset-on-init Reviewed-by: Suman Anna Tested-by: Keerthy Signed-off-by: Tony Lindgren --- arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi | 2 +- arch/arm/boot/dts/dra7-evm.dts | 2 +- arch/arm/boot/dts/dra7-l4.dtsi | 2 +- 3 files changed, 3 insertions(+), 3 deletions(-) (limited to 'arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi') diff --git a/arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi b/arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi index d02f5fa61e5f..df00d1756dae 100644 --- a/arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi +++ b/arch/arm/boot/dts/am57xx-beagle-x15-common.dtsi @@ -379,7 +379,7 @@ }; }; -&gpio7 { +&gpio7_target { ti,no-reset-on-init; ti,no-idle-on-init; }; diff --git a/arch/arm/boot/dts/dra7-evm.dts b/arch/arm/boot/dts/dra7-evm.dts index 714e971b912a..de7f85efaa51 100644 --- a/arch/arm/boot/dts/dra7-evm.dts +++ b/arch/arm/boot/dts/dra7-evm.dts @@ -498,7 +498,7 @@ phy-supply = <&ldousb_reg>; }; -&gpio7 { +&gpio7_target { ti,no-reset-on-init; ti,no-idle-on-init; }; diff --git a/arch/arm/boot/dts/dra7-l4.dtsi b/arch/arm/boot/dts/dra7-l4.dtsi index 23faedec08ab..63628e166c0c 100644 --- a/arch/arm/boot/dts/dra7-l4.dtsi +++ b/arch/arm/boot/dts/dra7-l4.dtsi @@ -1261,7 +1261,7 @@ }; }; - target-module@51000 { /* 0x48051000, ap 45 2e.0 */ + gpio7_target: target-module@51000 { /* 0x48051000, ap 45 2e.0 */ compatible = "ti,sysc-omap2", "ti,sysc"; ti,hwmods = "gpio7"; reg = <0x51000 0x4>, -- cgit v1.2.3