From b55f627feeb9d48fdbde3835e18afbc76712e49b Mon Sep 17 00:00:00 2001 From: David Brownell Date: Tue, 30 Jun 2009 11:41:26 -0700 Subject: spi: new spi->mode bits Add two new spi_device.mode bits to accomodate more protocol options, and pass them through to usermode drivers: * SPI_NO_CS ... a second 3-wire variant, where the chipselect line is removed instead of a data line; transfers are still full duplex. This obviously has STRONG protocol implications since the chipselect transitions can't be used to synchronize state transitions with the SPI master. * SPI_READY ... defines open drain signal that's pulled low to pause the clock. This defines a 5-wire variant (normal 4-wire SPI plus READY) and two 4-wire variants (READY plus each of the 3-wire flavors). Such hardware flow control can be a big win. There are ADC converters and flash chips that expose READY signals, but not many host controllers support it today. The spi_bitbang code should be changed to use SPI_NO_CS instead of its current nonportable hack. That's a mode most hardware can easily support (unlike SPI_READY). Signed-off-by: David Brownell Cc: "Paulraj, Sandeep" Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds --- include/linux/spi/spi.h | 2 ++ 1 file changed, 2 insertions(+) (limited to 'include/linux/spi/spi.h') diff --git a/include/linux/spi/spi.h b/include/linux/spi/spi.h index 9c4cd27f4685..743c933ac4e7 100644 --- a/include/linux/spi/spi.h +++ b/include/linux/spi/spi.h @@ -80,6 +80,8 @@ struct spi_device { #define SPI_LSB_FIRST 0x08 /* per-word bits-on-wire */ #define SPI_3WIRE 0x10 /* SI/SO signals shared */ #define SPI_LOOP 0x20 /* loopback mode */ +#define SPI_NO_CS 0x40 /* 1 dev/bus, no chipselect */ +#define SPI_READY 0x80 /* slave pulls low to pause */ u8 bits_per_word; int irq; void *controller_state; -- cgit v1.2.3