| Age | Commit message (Collapse) | Author | Files | Lines |
|---|
|
FruDevice service is always running no matter if entity-manager is used
or not. It scans for all FRU EEPROMs, parse and store information into
dbus.
This commit changes to get BMC MAC Address from FruDevice data instead
of ipmi-fru-parser.
Tested:
1. Clear environment in u-boot, boot BMC to Linux and check if the
eth1addr variable is set with value from FRU.
2. Change BMC MAC address from FRU's Board Extra. Reboot BMC and check
if the eth1addr variable is set with new BMC MAC Address
Signed-off-by: Thang Q. Nguyen <thang@os.amperecomputing.com>
Change-Id: I99b5d46c8a22b98402f749cdebd1c0aad3d6daf0
|
|
Run convert-overrides.py meta-ampere and update missing changes as
below:
- Change all _mtjade to :mtjade
- Change all _${PN} to :${PN}
Tested:
1. Check compilation without problem.
2. Check basic functions like switch UART mux, power control.
Signed-off-by: Thang Q. Nguyen <thang@os.amperecomputing.com>
Change-Id: I42038b2a98ed1951d6c770bdf49f5fc440f8163e
|
|
Support to get BMC MAC address from FRU over the FRU inventory
information (/xyz/openbmc_project/inventory/system/chassis/motherboard)
and update to the eth0 Ethernet interface and set the eth1addr u-boot
variable.
Tested:
1. Boot to u-boot, clear the eth1addr variable, save and reboot.
2. Boot to Linux:
- Check if the eth0 interface uses the MAC address in FRU.
root@mtjade:~# ip addr show dev eth0
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast qlen 1000
link/ether 70:e2:84:86:76:ba brd ff:ff:ff:ff:ff:ff
- Check if the eth1addr u-boot variable uses the MAC address in FRU
root@mtjade:~# fw_printenv eth1addr
eth1addr=70:E2:84:86:76:BA
Signed-off-by: Chanh Nguyen <chanh@os.amperecomputing.com>
Signed-off-by: Thang Q. Nguyen <thang@os.amperecomputing.com>
Change-Id: Ifb7eefbb17257545d026005f859d37ef562289b7
|
