Age | Commit message (Collapse) | Author | Files | Lines |
|
This brings the default network settings for Tatlin as a part of
`systemd-conf` package.
These settings contain a predefined IPv4 address for eth0 interface,
keep the possibility of getting an additional IP address from DHCP.
VALN4004 with predefined IPv6 address is also kept.
(From meta-yadro rev: 56e7efa11a0b281f39d160cd99c84b7a95632205)
Change-Id: Ibb025a1ae519f0843bfcb8ec71e009e2bc97141f
End-User-Impact: - BMC now has predefined IPv4 address on the eth0.
- VLAN4004 also present and has predefined IPv6 address
- BMC is able to get a dynamic IP address on eth0.
Signed-off-by: Alexander Filippov <a.filippov@yadro.com>
Signed-off-by: Andrew Geissler <geissonator@yahoo.com>
|
|
The phosphor-network now has the sync-mac feature.
It does the same thing as the first-boot-set-mac without any additional
services.
This commit enables this new feature in phosphor-network and removes
obsolete first-boot-set-mac service.
(From meta-yadro rev: fea7a8d7a57accd658aa60248cb203afc735c73b)
Change-Id: I31e530850b2550de70f72091c683153ecb6968a7
Signed-off-by: Alexander Filippov <a.filippov@yadro.com>
Signed-off-by: Andrew Geissler <geissonator@yahoo.com>
|
|
This adds VLAN4004 configuration to the nicole firmware image.
The IPv6 address will be chosen depending on the BMC position.
During the firmware upgrade the stored previous version of
`/etc/systemd/network/00-bmc-eth0.network` may prevent to start new
VLAN4004 interface.
This commit also adds a service which should fix this issue on the
first boot time after upgrade by adding necessary option to the
interface configuration file if it is not present yet.
Tested: BMC now has additional `eth0.4004` interface use static IPv6
address and this address depend on BMC position.
(From meta-yadro rev: 83aa32ac997e6dc66cc5e2041a0a3cb723e950d9)
Change-Id: I5fc6663ddee67aafcfa9f2004083d8a4a528950f
Signed-off-by: Alexander Filippov <a.filippov@yadro.com>
Signed-off-by: Andrew Geissler <geissonator@yahoo.com>
|
|
VPD contains general description of the BMC card and MAC address for
the Ethernet controller.
Physically, VPD is stored in the EEPROM AT24C256C, which is connected
to the Aspeed SoC via I2C and can be read or written through
the special device file /sys/bus/i2c/devices/0-0050/eeprom.
(From meta-yadro rev: 95f98dc7d5ccf2b221d2a5aea51bf411201f351c)
Signed-off-by: Artem Senichev <a.senichev@yadro.com>
Change-Id: I21624f154cfa1e92eddbc1739a4e053d00889b5a
Signed-off-by: Brad Bishop <bradleyb@fuzziesquirrel.com>
|