Merge tag 'net-5.18-rc2' of git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net

Pull networking fixes from Paolo Abeni:
 "Including fixes from bpf and netfilter.

  Current release - new code bugs:

   - mctp: correct mctp_i2c_header_create result

   - eth: fungible: fix reference to __udivdi3 on 32b builds

   - eth: micrel: remove latencies support lan8814

  Previous releases - regressions:

   - bpf: resolve to prog->aux->dst_prog->type only for BPF_PROG_TYPE_EXT

   - vrf: fix packet sniffing for traffic originating from ip tunnels

   - rxrpc: fix a race in rxrpc_exit_net()

   - dsa: revert "net: dsa: stop updating master MTU from master.c"

   - eth: ice: fix MAC address setting

  Previous releases - always broken:

   - tls: fix slab-out-of-bounds bug in decrypt_internal

   - bpf: support dual-stack sockets in bpf_tcp_check_syncookie

   - xdp: fix coalescing for page_pool fragment recycling

   - ovs: fix leak of nested actions

   - eth: sfc:
      - add missing xdp queue reinitialization
      - fix using uninitialized xdp tx_queue

   - eth: ice:
      - clear default forwarding VSI during VSI release
      - fix broken IFF_ALLMULTI handling
      - synchronize_rcu() when terminating rings

   - eth: qede: confirm skb is allocated before using

   - eth: aqc111: fix out-of-bounds accesses in RX fixup

   - eth: slip: fix NPD bug in sl_tx_timeout()"

* tag 'net-5.18-rc2' of git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net: (61 commits)
  drivers: net: slip: fix NPD bug in sl_tx_timeout()
  bpf: Adjust bpf_tcp_check_syncookie selftest to test dual-stack sockets
  bpf: Support dual-stack sockets in bpf_tcp_check_syncookie
  myri10ge: fix an incorrect free for skb in myri10ge_sw_tso
  net: usb: aqc111: Fix out-of-bounds accesses in RX fixup
  qede: confirm skb is allocated before using
  net: ipv6mr: fix unused variable warning with CONFIG_IPV6_PIMSM_V2=n
  net: phy: mscc-miim: reject clause 45 register accesses
  net: axiemac: use a phandle to reference pcs_phy
  dt-bindings: net: add pcs-handle attribute
  net: axienet: factor out phy_node in struct axienet_local
  net: axienet: setup mdio unconditionally
  net: sfc: fix using uninitialized xdp tx_queue
  rxrpc: fix a race in rxrpc_exit_net()
  net: openvswitch: fix leak of nested actions
  net: ethernet: mv643xx: Fix over zealous checking of_get_mac_address()
  net: openvswitch: don't send internal clone attribute to the userspace.
  net: micrel: Fix KS8851 Kconfig
  ice: clear cmd_type_offset_bsz for TX rings
  ice: xsk: fix VSI state check in ice_xsk_wakeup()
  ...

3 files changed, 13 insertions, 18 deletions

diff --git a/Documentation/devicetree/bindings/net/ethernet-controller.yaml b/Documentation/devicetree/bindings/net/ethernet-controller.yaml
index 817794e56227..4f15463611f8 100644
--- a/Documentation/devicetree/bindings/net/ethernet-controller.yaml
+++ b/Documentation/devicetree/bindings/net/ethernet-controller.yaml
@@ -106,6 +106,12 @@ properties:
   phy-mode:
     $ref: "#/properties/phy-connection-type"
 
+  pcs-handle:
+    $ref: /schemas/types.yaml#/definitions/phandle
+    description:
+      Specifies a reference to a node representing a PCS PHY device on a MDIO
+      bus to link with an external PHY (phy-handle) if exists.
+
   phy-handle:
     $ref: /schemas/types.yaml#/definitions/phandle
     description:
diff --git a/Documentation/devicetree/bindings/net/micrel.txt b/Documentation/devicetree/bindings/net/micrel.txt
index c5ab62c39133..8d157f0295a5 100644
--- a/Documentation/devicetree/bindings/net/micrel.txt
+++ b/Documentation/devicetree/bindings/net/micrel.txt
@@ -45,20 +45,3 @@ Optional properties:
 
 	In fiber mode, auto-negotiation is disabled and the PHY can only work in
 	100base-fx (full and half duplex) modes.
-
- - lan8814,ignore-ts: If present the PHY will not support timestamping.
-
-	This option acts as check whether Timestamping is supported by
-	hardware or not. LAN8814 phy support hardware tmestamping.
-
- - lan8814,latency_rx_10: Configures Latency value of phy in ingress at 10 Mbps.
-
- - lan8814,latency_tx_10: Configures Latency value of phy in egress at 10 Mbps.
-
- - lan8814,latency_rx_100: Configures Latency value of phy in ingress at 100 Mbps.
-
- - lan8814,latency_tx_100: Configures Latency value of phy in egress at 100 Mbps.
-
- - lan8814,latency_rx_1000: Configures Latency value of phy in ingress at 1000 Mbps.
-
- - lan8814,latency_tx_1000: Configures Latency value of phy in egress at 1000 Mbps.
diff --git a/Documentation/devicetree/bindings/net/xilinx_axienet.txt b/Documentation/devicetree/bindings/net/xilinx_axienet.txt
index b8e4894bc634..1aa4c6006cd0 100644
--- a/Documentation/devicetree/bindings/net/xilinx_axienet.txt
+++ b/Documentation/devicetree/bindings/net/xilinx_axienet.txt
@@ -26,7 +26,8 @@ Required properties:
 		  specified, the TX/RX DMA interrupts should be on that node
 		  instead, and only the Ethernet core interrupt is optionally
 		  specified here.
-- phy-handle	: Should point to the external phy device.
+- phy-handle	: Should point to the external phy device if exists. Pointing
+		  this to the PCS/PMA PHY is deprecated and should be avoided.
 		  See ethernet.txt file in the same directory.
 - xlnx,rxmem	: Set to allocated memory buffer for Rx/Tx in the hardware
 
@@ -68,6 +69,11 @@ Optional properties:
 		  required through the core's MDIO interface (i.e. always,
 		  unless the PHY is accessed through a different bus).
 
+ - pcs-handle: 	  Phandle to the internal PCS/PMA PHY in SGMII or 1000Base-X
+		  modes, where "pcs-handle" should be used to point
+		  to the PCS/PMA PHY, and "phy-handle" should point to an
+		  external PHY if exists.
+
 Example:
 	axi_ethernet_eth: ethernet@40c00000 {
 		compatible = "xlnx,axi-ethernet-1.00.a";