Merge tag 'dt-3.15' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc

Pull ARM SoC device tree changes from Arnd Bergmann:
 "A large part of the arm-soc patches are nowadays DT changes, adding
  support for new SoCs, boards and devices without changing kernel
  source.  The plan is still to move the devicetree files out of the
  kernel tree and reduce the amount of churn going on here, but we keep
  finding reasons to delay doing that.

  Changes are really all over the place, with little sticking out
  particularly.  We have contributions from a total of 116 people in
  this branch.

  Unfortunately, the size of this branch also causes a significant
  number of conflicts at the moment, typically when subsystem
  maintainers merge patches that change the driver at the same time as
  the dts files.  In most cases this could be avoided because the dts
  changes are supposed to be compatible in both ways, and we are asking
  everyone to send ARM dts changes through our tree only"

* tag 'dt-3.15' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc: (541 commits)
  dts: stmmac: Document the clocks property in the stmmac base document
  dts: socfpga: Add DTS entry for adding the stmmac glue layer for stmmac.
  ARM: STi: stih41x: Add support for the FSM Serial Flash Controller
  ARM: STi: stih416: Add support for the FSM Serial Flash Controller
  ARM: tegra: fix Dalmore pinctrl configuration
  ARM: dts: keystone: use common "ti,keystone" compatible instead of -evm
  ARM: dts: k2hk-evm: set ubifs partition size for 512M NAND
  ARM: dts: Build all keystone dt blobs
  ARM: dts: keystone: Fix control register range for clktsip
  ARM: dts: keystone: Fix domain register range for clkfftc1
  ARM: dts: bcm28155-ap: leave camldo1 on to fix reboot
  ARM: dts: add bcm590xx pmu support and enable for bcm28155-ap
  ARM: dts: bcm21664: Add device tree files.
  ARM: DT: bcm21664: Device tree bindings
  ARM: efm32: properly namespace i2c location property
  ARM: efm32: fix unit address part in USART2 device nodes' names
  ARM: mvebu: Enable NAND controller in Armada 385-DB
  ARM: mvebu: Add support for NAND controller in Armada 38x SoC
  ARM: mvebu: Add the Core Divider clock to Armada 38x SoCs
  ARM: mvebu: Add a 2 GHz fixed-clock on Armada 38x SoCs
  ...

1 files changed, 37 insertions, 3 deletions

diff --git a/arch/arm/boot/dts/imx51-apf51.dts b/arch/arm/boot/dts/imx51-apf51.dts
index b3606993f2e8..e88b2a6be079 100644
--- a/arch/arm/boot/dts/imx51-apf51.dts
+++ b/arch/arm/boot/dts/imx51-apf51.dts
@@ -34,13 +34,47 @@
 
 &fec {
 	pinctrl-names = "default";
-	pinctrl-0 = <&pinctrl_fec_2>;
+	pinctrl-0 = <&pinctrl_fec>;
 	phy-mode = "mii";
-	phy-reset-gpios = <&gpio3 0 0>;
+	phy-reset-gpios = <&gpio3 0 GPIO_ACTIVE_HIGH>;
 	phy-reset-duration = <1>;
 	status = "okay";
 };
 
+&iomuxc {
+	imx51-apf51 {
+		pinctrl_fec: fecgrp {
+			fsl,pins = <
+				MX51_PAD_DI_GP3__FEC_TX_ER		0x80000000
+				MX51_PAD_DI2_PIN4__FEC_CRS		0x80000000
+				MX51_PAD_DI2_PIN2__FEC_MDC		0x80000000
+				MX51_PAD_DI2_PIN3__FEC_MDIO		0x80000000
+				MX51_PAD_DI2_DISP_CLK__FEC_RDATA1	0x80000000
+				MX51_PAD_DI_GP4__FEC_RDATA2		0x80000000
+				MX51_PAD_DISP2_DAT0__FEC_RDATA3		0x80000000
+				MX51_PAD_DISP2_DAT1__FEC_RX_ER		0x80000000
+				MX51_PAD_DISP2_DAT6__FEC_TDATA1		0x80000000
+				MX51_PAD_DISP2_DAT7__FEC_TDATA2		0x80000000
+				MX51_PAD_DISP2_DAT8__FEC_TDATA3		0x80000000
+				MX51_PAD_DISP2_DAT9__FEC_TX_EN		0x80000000
+				MX51_PAD_DISP2_DAT10__FEC_COL		0x80000000
+				MX51_PAD_DISP2_DAT11__FEC_RX_CLK	0x80000000
+				MX51_PAD_DISP2_DAT12__FEC_RX_DV		0x80000000
+				MX51_PAD_DISP2_DAT13__FEC_TX_CLK	0x80000000
+				MX51_PAD_DISP2_DAT14__FEC_RDATA0	0x80000000
+				MX51_PAD_DISP2_DAT15__FEC_TDATA0	0x80000000
+			>;
+		};
+
+		pinctrl_uart3: uart3grp {
+			fsl,pins = <
+				MX51_PAD_UART3_RXD__UART3_RXD		0x1c5
+				MX51_PAD_UART3_TXD__UART3_TXD		0x1c5
+			>;
+		};
+	};
+};
+
 &nfc {
 	nand-bus-width = <8>;
 	nand-ecc-mode = "hw";
@@ -50,6 +84,6 @@
 
 &uart3 {
 	pinctrl-names = "default";
-	pinctrl-0 = <&pinctrl_uart3_2>;
+	pinctrl-0 = <&pinctrl_uart3>;
 	status = "okay";
 };