Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6: (1674 commits)
  qlcnic: adding co maintainer
  ixgbe: add support for active DA cables
  ixgbe: dcb, do not tag tc_prio_control frames
  ixgbe: fix ixgbe_tx_is_paused logic
  ixgbe: always enable vlan strip/insert when DCB is enabled
  ixgbe: remove some redundant code in setting FCoE FIP filter
  ixgbe: fix wrong offset to fc_frame_header in ixgbe_fcoe_ddp
  ixgbe: fix header len when unsplit packet overflows to data buffer
  ipv6: Never schedule DAD timer on dead address
  ipv6: Use POSTDAD state
  ipv6: Use state_lock to protect ifa state
  ipv6: Replace inet6_ifaddr->dead with state
  cxgb4: notify upper drivers if the device is already up when they load
  cxgb4: keep interrupts available when the ports are brought down
  cxgb4: fix initial addition of MAC address
  cnic: Return SPQ credit to bnx2x after ring setup and shutdown.
  cnic: Convert cnic_local_flags to atomic ops.
  can: Fix SJA1000 command register writes on SMP systems
  bridge: fix build for CONFIG_SYSFS disabled
  ARCNET: Limit com20020 PCI ID matches for SOHARD cards
  ...

Fix up various conflicts with pcmcia tree drivers/net/
{pcmcia/3c589_cs.c, wireless/orinoco/orinoco_cs.c and
wireless/orinoco/spectrum_cs.c} and feature removal
(Documentation/feature-removal-schedule.txt).

Also fix a non-content conflict due to pm_qos_requirement getting
renamed in the PM tree (now pm_qos_request) in net/mac80211/scan.c

1 files changed, 12 insertions, 14 deletions

diff --git a/drivers/net/e1000e/e1000.h b/drivers/net/e1000e/e1000.h
index ee32b9b27a9f..c0b3db40bd73 100644
--- a/drivers/net/e1000e/e1000.h
+++ b/drivers/net/e1000e/e1000.h
@@ -43,25 +43,16 @@
 
 struct e1000_info;
 
-#define e_printk(level, adapter, format, arg...) \
-	printk(level "%s: %s: " format, pci_name(adapter->pdev), \
-	       adapter->netdev->name, ## arg)
-
-#ifdef DEBUG
 #define e_dbg(format, arg...) \
-	e_printk(KERN_DEBUG , hw->adapter, format, ## arg)
-#else
-#define e_dbg(format, arg...) do { (void)(hw); } while (0)
-#endif
-
+	netdev_dbg(hw->adapter->netdev, format, ## arg)
 #define e_err(format, arg...) \
-	e_printk(KERN_ERR, adapter, format, ## arg)
+	netdev_err(adapter->netdev, format, ## arg)
 #define e_info(format, arg...) \
-	e_printk(KERN_INFO, adapter, format, ## arg)
+	netdev_info(adapter->netdev, format, ## arg)
 #define e_warn(format, arg...) \
-	e_printk(KERN_WARNING, adapter, format, ## arg)
+	netdev_warn(adapter->netdev, format, ## arg)
 #define e_notice(format, arg...) \
-	e_printk(KERN_NOTICE, adapter, format, ## arg)
+	netdev_notice(adapter->netdev, format, ## arg)
 
 
 /* Interrupt modes, as used by the IntMode parameter */
@@ -159,6 +150,9 @@ struct e1000_info;
 #define HV_M_STATUS_SPEED_1000            0x0200
 #define HV_M_STATUS_LINK_UP               0x0040
 
+/* Time to wait before putting the device into D3 if there's no link (in ms). */
+#define LINK_TIMEOUT		100
+
 enum e1000_boards {
 	board_82571,
 	board_82572,
@@ -195,6 +189,8 @@ struct e1000_buffer {
 			unsigned long time_stamp;
 			u16 length;
 			u16 next_to_watch;
+			unsigned int segs;
+			unsigned int bytecount;
 			u16 mapped_as_page;
 		};
 		/* Rx */
@@ -370,6 +366,8 @@ struct e1000_adapter {
 	struct work_struct update_phy_task;
 	struct work_struct led_blink_task;
 	struct work_struct print_hang_task;
+
+	bool idle_check;
 };
 
 struct e1000_info {