Expose c0 and SW encap ICM for RDMA

These two series from Mark and Shun extend RDMA mlx5 API.

Mark's series provides c0 register used to match egress
traffic sent by local device.

Shun's series adds new type for ICM area.

Link: https://lore.kernel.org/all/cover.1701871118.git.leon@kernel.org
Signed-off-by: Leon Romanovsky <leon@kernel.org>

1 files changed, 29 insertions, 16 deletions

diff --git a/drivers/net/ethernet/cortina/gemini.c b/drivers/net/ethernet/cortina/gemini.c
index 5423fe26b4ef..78287cfcbf63 100644
--- a/drivers/net/ethernet/cortina/gemini.c
+++ b/drivers/net/ethernet/cortina/gemini.c
@@ -432,8 +432,8 @@ static const struct gmac_max_framelen gmac_maxlens[] = {
 		.val = CONFIG0_MAXLEN_1536,
 	},
 	{
-		.max_l3_len = 1542,
-		.val = CONFIG0_MAXLEN_1542,
+		.max_l3_len = 1548,
+		.val = CONFIG0_MAXLEN_1548,
 	},
 	{
 		.max_l3_len = 9212,
@@ -1145,6 +1145,7 @@ static int gmac_map_tx_bufs(struct net_device *netdev, struct sk_buff *skb,
 	dma_addr_t mapping;
 	unsigned short mtu;
 	void *buffer;
+	int ret;
 
 	mtu  = ETH_HLEN;
 	mtu += netdev->mtu;
@@ -1159,9 +1160,30 @@ static int gmac_map_tx_bufs(struct net_device *netdev, struct sk_buff *skb,
 		word3 |= mtu;
 	}
 
-	if (skb->ip_summed != CHECKSUM_NONE) {
+	if (skb->len >= ETH_FRAME_LEN) {
+		/* Hardware offloaded checksumming isn't working on frames
+		 * bigger than 1514 bytes. A hypothesis about this is that the
+		 * checksum buffer is only 1518 bytes, so when the frames get
+		 * bigger they get truncated, or the last few bytes get
+		 * overwritten by the FCS.
+		 *
+		 * Just use software checksumming and bypass on bigger frames.
+		 */
+		if (skb->ip_summed == CHECKSUM_PARTIAL) {
+			ret = skb_checksum_help(skb);
+			if (ret)
+				return ret;
+		}
+		word1 |= TSS_BYPASS_BIT;
+	} else if (skb->ip_summed == CHECKSUM_PARTIAL) {
 		int tcp = 0;
 
+		/* We do not switch off the checksumming on non TCP/UDP
+		 * frames: as is shown from tests, the checksumming engine
+		 * is smart enough to see that a frame is not actually TCP
+		 * or UDP and then just pass it through without any changes
+		 * to the frame.
+		 */
 		if (skb->protocol == htons(ETH_P_IP)) {
 			word1 |= TSS_IP_CHKSUM_BIT;
 			tcp = ip_hdr(skb)->protocol == IPPROTO_TCP;
@@ -1978,15 +2000,6 @@ static int gmac_change_mtu(struct net_device *netdev, int new_mtu)
 	return 0;
 }
 
-static netdev_features_t gmac_fix_features(struct net_device *netdev,
-					   netdev_features_t features)
-{
-	if (netdev->mtu + ETH_HLEN + VLAN_HLEN > MTU_SIZE_BIT_MASK)
-		features &= ~GMAC_OFFLOAD_FEATURES;
-
-	return features;
-}
-
 static int gmac_set_features(struct net_device *netdev,
 			     netdev_features_t features)
 {
@@ -2212,7 +2225,6 @@ static const struct net_device_ops gmac_351x_ops = {
 	.ndo_set_mac_address	= gmac_set_mac_address,
 	.ndo_get_stats64	= gmac_get_stats64,
 	.ndo_change_mtu		= gmac_change_mtu,
-	.ndo_fix_features	= gmac_fix_features,
 	.ndo_set_features	= gmac_set_features,
 };
 
@@ -2464,11 +2476,12 @@ static int gemini_ethernet_port_probe(struct platform_device *pdev)
 
 	netdev->hw_features = GMAC_OFFLOAD_FEATURES;
 	netdev->features |= GMAC_OFFLOAD_FEATURES | NETIF_F_GRO;
-	/* We can handle jumbo frames up to 10236 bytes so, let's accept
-	 * payloads of 10236 bytes minus VLAN and ethernet header
+	/* We can receive jumbo frames up to 10236 bytes but only
+	 * transmit 2047 bytes so, let's accept payloads of 2047
+	 * bytes minus VLAN and ethernet header
 	 */
 	netdev->min_mtu = ETH_MIN_MTU;
-	netdev->max_mtu = 10236 - VLAN_ETH_HLEN;
+	netdev->max_mtu = MTU_SIZE_BIT_MASK - VLAN_ETH_HLEN;
 
 	port->freeq_refill = 0;
 	netif_napi_add(netdev, &port->napi, gmac_napi_poll);