Merge tag 'net-next-6.7' of git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net-next

Pull networking updates from Jakub Kicinski:
 "Core & protocols:

   - Support usec resolution of TCP timestamps, enabled selectively by a
     route attribute.

   - Defer regular TCP ACK while processing socket backlog, try to send
     a cumulative ACK at the end. Increase single TCP flow performance
     on a 200Gbit NIC by 20% (100Gbit -> 120Gbit).

   - The Fair Queuing (FQ) packet scheduler:
       - add built-in 3 band prio / WRR scheduling
       - support bypass if the qdisc is mostly idle (5% speed up for TCP RR)
       - improve inactive flow reporting
       - optimize the layout of structures for better cache locality

   - Support TCP Authentication Option (RFC 5925, TCP-AO), a more modern
     replacement for the old MD5 option.

   - Add more retransmission timeout (RTO) related statistics to
     TCP_INFO.

   - Support sending fragmented skbs over vsock sockets.

   - Make sure we send SIGPIPE for vsock sockets if socket was
     shutdown().

   - Add sysctl for ignoring lower limit on lifetime in Router
     Advertisement PIO, based on an in-progress IETF draft.

   - Add sysctl to control activation of TCP ping-pong mode.

   - Add sysctl to make connection timeout in MPTCP configurable.

   - Support rcvlowat and notsent_lowat on MPTCP sockets, to help apps
     limit the number of wakeups.

   - Support netlink GET for MDB (multicast forwarding), allowing user
     space to request a single MDB entry instead of dumping the entire
     table.

   - Support selective FDB flushing in the VXLAN tunnel driver.

   - Allow limiting learned FDB entries in bridges, prevent OOM attacks.

   - Allow controlling via configfs netconsole targets which were
     created via the kernel cmdline at boot, rather than via configfs at
     runtime.

   - Support multiple PTP timestamp event queue readers with different
     filters.

   - MCTP over I3C.

  BPF:

   - Add new veth-like netdevice where BPF program defines the logic of
     the xmit routine. It can operate in L3 and L2 mode.

   - Support exceptions - allow asserting conditions which should never
     be true but are hard for the verifier to infer. With some extra
     flexibility around handling of the exit / failure:

          https://lwn.net/Articles/938435/

   - Add support for local per-cpu kptr, allow allocating and storing
     per-cpu objects in maps. Access to those objects operates on the
     value for the current CPU.

     This allows to deprecate local one-off implementations of per-CPU
     storage like BPF_MAP_TYPE_PERCPU_CGROUP_STORAGE maps.

   - Extend cgroup BPF sockaddr hooks for UNIX sockets. The use case is
     for systemd to re-implement the LogNamespace feature which allows
     running multiple instances of systemd-journald to process the logs
     of different services.

   - Enable open-coded task_vma iteration, after maple tree conversion
     made it hard to directly walk VMAs in tracing programs.

   - Add open-coded task, css_task and css iterator support. One of the
     use cases is customizable OOM victim selection via BPF.

   - Allow source address selection with bpf_*_fib_lookup().

   - Add ability to pin BPF timer to the current CPU.

   - Prevent creation of infinite loops by combining tail calls and
     fentry/fexit programs.

   - Add missed stats for kprobes to retrieve the number of missed
     kprobe executions and subsequent executions of BPF programs.

   - Inherit system settings for CPU security mitigations.

   - Add BPF v4 CPU instruction support for arm32 and s390x.

  Changes to common code:

   - overflow: add DEFINE_FLEX() for on-stack definition of structs with
     flexible array members.

   - Process doc update with more guidance for reviewers.

  Driver API:

   - Simplify locking in WiFi (cfg80211 and mac80211 layers), use wiphy
     mutex in most places and remove a lot of smaller locks.

   - Create a common DPLL configuration API. Allow configuring and
     querying state of PLL circuits used for clock syntonization, in
     network time distribution.

   - Unify fragmented and full page allocation APIs in page pool code.
     Let drivers be ignorant of PAGE_SIZE.

   - Rework PHY state machine to avoid races with calls to phy_stop().

   - Notify DSA drivers of MAC address changes on user ports, improve
     correctness of offloads which depend on matching port MAC
     addresses.

   - Allow antenna control on injected WiFi frames.

   - Reduce the number of variants of napi_schedule().

   - Simplify error handling when composing devlink health messages.

  Misc:

   - A lot of KCSAN data race "fixes", from Eric.

   - A lot of __counted_by() annotations, from Kees.

   - A lot of strncpy -> strscpy and printf format fixes.

   - Replace master/slave terminology with conduit/user in DSA drivers.

   - Handful of KUnit tests for netdev and WiFi core.

  Removed:

   - AppleTalk COPS.

   - AppleTalk ipddp.

   - TI AR7 CPMAC Ethernet driver.

  Drivers:

   - Ethernet high-speed NICs:
      - Intel (100G, ice, idpf):
         - add a driver for the Intel E2000 IPUs
         - make CRC/FCS stripping configurable
         - cross-timestamping for E823 devices
         - basic support for E830 devices
         - use aux-bus for managing client drivers
         - i40e: report firmware versions via devlink
      - nVidia/Mellanox:
         - support 4-port NICs
         - increase max number of channels to 256
         - optimize / parallelize SF creation flow
      - Broadcom (bnxt):
         - enhance NIC temperature reporting
         - support PAM4 speeds and lane configuration
      - Marvell OcteonTX2:
         - PTP pulse-per-second output support
         - enable hardware timestamping for VFs
      - Solarflare/AMD:
         - conntrack NAT offload and offload for tunnels
      - Wangxun (ngbe/txgbe):
         - expose HW statistics
      - Pensando/AMD:
         - support PCI level reset
         - narrow down the condition under which skbs are linearized
      - Netronome/Corigine (nfp):
         - support CHACHA20-POLY1305 crypto in IPsec offload

   - Ethernet NICs embedded, slower, virtual:
      - Synopsys (stmmac):
         - add Loongson-1 SoC support
         - enable use of HW queues with no offload capabilities
         - enable PPS input support on all 5 channels
         - increase TX coalesce timer to 5ms
      - RealTek USB (r8152): improve efficiency of Rx by using GRO frags
      - xen: support SW packet timestamping
      - add drivers for implementations based on TI's PRUSS (AM64x EVM)

   - nVidia/Mellanox Ethernet datacenter switches:
      - avoid poor HW resource use on Spectrum-4 by better block
        selection for IPv6 multicast forwarding and ordering of blocks
        in ACL region

   - Ethernet embedded switches:
      - Microchip:
         - support configuring the drive strength for EMI compliance
         - ksz9477: partial ACL support
         - ksz9477: HSR offload
         - ksz9477: Wake on LAN
      - Realtek:
         - rtl8366rb: respect device tree config of the CPU port

   - Ethernet PHYs:
      - support Broadcom BCM5221 PHYs
      - TI dp83867: support hardware LED blinking

   - CAN:
      - add support for Linux-PHY based CAN transceivers
      - at91_can: clean up and use rx-offload helpers

   - WiFi:
      - MediaTek (mt76):
         - new sub-driver for mt7925 USB/PCIe devices
         - HW wireless <> Ethernet bridging in MT7988 chips
         - mt7603/mt7628 stability improvements
      - Qualcomm (ath12k):
         - WCN7850:
            - enable 320 MHz channels in 6 GHz band
            - hardware rfkill support
            - enable IEEE80211_HW_SINGLE_SCAN_ON_ALL_BANDS to
              make scan faster
            - read board data variant name from SMBIOS
        - QCN9274: mesh support
      - RealTek (rtw89):
         - TDMA-based multi-channel concurrency (MCC)
      - Silicon Labs (wfx):
         - Remain-On-Channel (ROC) support

   - Bluetooth:
      - ISO: many improvements for broadcast support
      - mark BCM4378/BCM4387 as BROKEN_LE_CODED
      - add support for QCA2066
      - btmtksdio: enable Bluetooth wakeup from suspend"

* tag 'net-next-6.7' of git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net-next: (1816 commits)
  net: pcs: xpcs: Add 2500BASE-X case in get state for XPCS drivers
  net: bpf: Use sockopt_lock_sock() in ip_sock_set_tos()
  net: mana: Use xdp_set_features_flag instead of direct assignment
  vxlan: Cleanup IFLA_VXLAN_PORT_RANGE entry in vxlan_get_size()
  iavf: delete the iavf client interface
  iavf: add a common function for undoing the interrupt scheme
  iavf: use unregister_netdev
  iavf: rely on netdev's own registered state
  iavf: fix the waiting time for initial reset
  iavf: in iavf_down, don't queue watchdog_task if comms failed
  iavf: simplify mutex_trylock+sleep loops
  iavf: fix comments about old bit locks
  doc/netlink: Update schema to support cmd-cnt-name and cmd-max-name
  tools: ynl: introduce option to process unknown attributes or types
  ipvlan: properly track tx_errors
  netdevsim: Block until all devices are released
  nfp: using napi_build_skb() to replace build_skb()
  net: dsa: microchip: ksz9477: Fix spelling mistake "Enery" -> "Energy"
  net: dsa: microchip: Ensure Stable PME Pin State for Wake-on-LAN
  net: dsa: microchip: Refactor switch shutdown routine for WoL preparation
  ...

1 files changed, 87 insertions, 0 deletions

diff --git a/tools/testing/vsock/msg_zerocopy_common.c b/tools/testing/vsock/msg_zerocopy_common.c
new file mode 100644
index 000000000000..5a4bdf7b5132
--- /dev/null
+++ b/tools/testing/vsock/msg_zerocopy_common.c
@@ -0,0 +1,87 @@
+// SPDX-License-Identifier: GPL-2.0-only
+/* Some common code for MSG_ZEROCOPY logic
+ *
+ * Copyright (C) 2023 SberDevices.
+ *
+ * Author: Arseniy Krasnov <avkrasnov@salutedevices.com>
+ */
+
+#include <stdio.h>
+#include <stdlib.h>
+#include <sys/types.h>
+#include <sys/socket.h>
+#include <linux/errqueue.h>
+
+#include "msg_zerocopy_common.h"
+
+void enable_so_zerocopy(int fd)
+{
+	int val = 1;
+
+	if (setsockopt(fd, SOL_SOCKET, SO_ZEROCOPY, &val, sizeof(val))) {
+		perror("setsockopt");
+		exit(EXIT_FAILURE);
+	}
+}
+
+void vsock_recv_completion(int fd, const bool *zerocopied)
+{
+	struct sock_extended_err *serr;
+	struct msghdr msg = { 0 };
+	char cmsg_data[128];
+	struct cmsghdr *cm;
+	ssize_t res;
+
+	msg.msg_control = cmsg_data;
+	msg.msg_controllen = sizeof(cmsg_data);
+
+	res = recvmsg(fd, &msg, MSG_ERRQUEUE);
+	if (res) {
+		fprintf(stderr, "failed to read error queue: %zi\n", res);
+		exit(EXIT_FAILURE);
+	}
+
+	cm = CMSG_FIRSTHDR(&msg);
+	if (!cm) {
+		fprintf(stderr, "cmsg: no cmsg\n");
+		exit(EXIT_FAILURE);
+	}
+
+	if (cm->cmsg_level != SOL_VSOCK) {
+		fprintf(stderr, "cmsg: unexpected 'cmsg_level'\n");
+		exit(EXIT_FAILURE);
+	}
+
+	if (cm->cmsg_type != VSOCK_RECVERR) {
+		fprintf(stderr, "cmsg: unexpected 'cmsg_type'\n");
+		exit(EXIT_FAILURE);
+	}
+
+	serr = (void *)CMSG_DATA(cm);
+	if (serr->ee_origin != SO_EE_ORIGIN_ZEROCOPY) {
+		fprintf(stderr, "serr: wrong origin: %u\n", serr->ee_origin);
+		exit(EXIT_FAILURE);
+	}
+
+	if (serr->ee_errno) {
+		fprintf(stderr, "serr: wrong error code: %u\n", serr->ee_errno);
+		exit(EXIT_FAILURE);
+	}
+
+	/* This flag is used for tests, to check that transmission was
+	 * performed as expected: zerocopy or fallback to copy. If NULL
+	 * - don't care.
+	 */
+	if (!zerocopied)
+		return;
+
+	if (*zerocopied && (serr->ee_code & SO_EE_CODE_ZEROCOPY_COPIED)) {
+		fprintf(stderr, "serr: was copy instead of zerocopy\n");
+		exit(EXIT_FAILURE);
+	}
+
+	if (!*zerocopied && !(serr->ee_code & SO_EE_CODE_ZEROCOPY_COPIED)) {
+		fprintf(stderr, "serr: was zerocopy instead of copy\n");
+		exit(EXIT_FAILURE);
+	}
+}