diff options
Diffstat (limited to 'Documentation/devicetree/bindings/iio/gyroscope/invensense,mpu3050.txt')
-rw-r--r-- | Documentation/devicetree/bindings/iio/gyroscope/invensense,mpu3050.txt | 45 |
1 files changed, 0 insertions, 45 deletions
diff --git a/Documentation/devicetree/bindings/iio/gyroscope/invensense,mpu3050.txt b/Documentation/devicetree/bindings/iio/gyroscope/invensense,mpu3050.txt deleted file mode 100644 index 233fe207aded..000000000000 --- a/Documentation/devicetree/bindings/iio/gyroscope/invensense,mpu3050.txt +++ /dev/null @@ -1,45 +0,0 @@ -Invensense MPU-3050 Gyroscope device tree bindings - -Required properties: - - compatible : should be "invensense,mpu3050" - - reg : the I2C address of the sensor - -Optional properties: - - interrupts : interrupt mapping for the trigger interrupt from the - internal oscillator. The following IRQ modes are supported: - IRQ_TYPE_EDGE_RISING, IRQ_TYPE_EDGE_FALLING, IRQ_TYPE_LEVEL_HIGH and - IRQ_TYPE_LEVEL_LOW. The driver should detect and configure the hardware - for the desired interrupt type. - - vdd-supply : supply regulator for the main power voltage. - - vlogic-supply : supply regulator for the signal voltage. - - mount-matrix : see iio/mount-matrix.txt - -Optional subnodes: - - The MPU-3050 will pass through and forward the I2C signals from the - incoming I2C bus, alternatively drive traffic to a slave device (usually - an accelerometer) on its own initiative. Therefore is supports a subnode - i2c gate node. For details see: i2c/i2c-gate.txt - -Example: - -mpu3050@68 { - compatible = "invensense,mpu3050"; - reg = <0x68>; - interrupt-parent = <&foo>; - interrupts = <12 IRQ_TYPE_EDGE_FALLING>; - vdd-supply = <&bar>; - vlogic-supply = <&baz>; - - /* External I2C interface */ - i2c-gate { - #address-cells = <1>; - #size-cells = <0>; - - fnord@18 { - compatible = "fnord"; - reg = <0x18>; - interrupt-parent = <&foo>; - interrupts = <13 IRQ_TYPE_EDGE_FALLING>; - }; - }; -}; |