summaryrefslogtreecommitdiff
path: root/Documentation/hwmon/sht3x.rst
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/hwmon/sht3x.rst')
-rw-r--r--Documentation/hwmon/sht3x.rst18
1 files changed, 9 insertions, 9 deletions
diff --git a/Documentation/hwmon/sht3x.rst b/Documentation/hwmon/sht3x.rst
index 95a850d5b2c1..87864ffd1777 100644
--- a/Documentation/hwmon/sht3x.rst
+++ b/Documentation/hwmon/sht3x.rst
@@ -28,15 +28,8 @@ The device communicates with the I2C protocol. Sensors can have the I2C
addresses 0x44 or 0x45, depending on the wiring. See
Documentation/i2c/instantiating-devices.rst for methods to instantiate the device.
-There are two options configurable by means of sht3x_platform_data:
-
-1. blocking (pull the I2C clock line down while performing the measurement) or
- non-blocking mode. Blocking mode will guarantee the fastest result but
- the I2C bus will be busy during that time. By default, non-blocking mode
- is used. Make sure clock-stretching works properly on your device if you
- want to use blocking mode.
-2. high or low accuracy. High accuracy is used by default and using it is
- strongly recommended.
+Even if sht3x sensor supports clock-strech(blocking mode) and non-strench
+(non-blocking mode) in single-shot mode, this driver only supports the latter.
The sht3x sensor supports a single shot mode as well as 5 periodic measure
modes, which can be controlled with the update_interval sysfs interface.
@@ -85,4 +78,11 @@ heater_enable: heater enable, heating element removes excess humidity from
update_interval: update interval, 0 for single shot, interval in msec
for periodic measurement. If the interval is not supported
by the sensor, the next faster interval is chosen
+repeatability: write or read repeatability, higher repeatability means
+ longer measurement duration, lower noise level and
+ larger energy consumption:
+
+ - 0: low repeatability
+ - 1: medium repeatability
+ - 2: high repeatability
=================== ============================================================