diff options
Diffstat (limited to 'drivers/bluetooth/hci_qca.c')
-rw-r--r-- | drivers/bluetooth/hci_qca.c | 46 |
1 files changed, 28 insertions, 18 deletions
diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c index 8a60ad7acd70..0c9c9ee56592 100644 --- a/drivers/bluetooth/hci_qca.c +++ b/drivers/bluetooth/hci_qca.c @@ -7,7 +7,6 @@ * * Copyright (C) 2007 Texas Instruments, Inc. * Copyright (c) 2010, 2012, 2018 The Linux Foundation. All rights reserved. - * Copyright (c) 2023 Qualcomm Innovation Center, Inc. All rights reserved. * * Acknowledgements: * This file is based on hci_ll.c, which was... @@ -226,6 +225,7 @@ struct qca_serdev { struct qca_power *bt_power; u32 init_speed; u32 oper_speed; + bool bdaddr_property_broken; const char *firmware_name; }; @@ -1672,6 +1672,9 @@ static bool qca_wakeup(struct hci_dev *hdev) struct hci_uart *hu = hci_get_drvdata(hdev); bool wakeup; + if (!hu->serdev) + return true; + /* BT SoC attached through the serial bus is handled by the serdev driver. * So we need to use the device handle of the serdev driver to get the * status of device may wakeup. @@ -1843,6 +1846,7 @@ static int qca_setup(struct hci_uart *hu) const char *firmware_name = qca_get_firmware_name(hu); int ret; struct qca_btsoc_version ver; + struct qca_serdev *qcadev; const char *soc_name; ret = qca_check_speeds(hu); @@ -1904,16 +1908,9 @@ retry: case QCA_WCN6750: case QCA_WCN6855: case QCA_WCN7850: - - /* Set BDA quirk bit for reading BDA value from fwnode property - * only if that property exist in DT. - */ - if (fwnode_property_present(dev_fwnode(hdev->dev.parent), "local-bd-address")) { - set_bit(HCI_QUIRK_USE_BDADDR_PROPERTY, &hdev->quirks); - bt_dev_info(hdev, "setting quirk bit to read BDA from fwnode later"); - } else { - bt_dev_dbg(hdev, "local-bd-address` is not present in the devicetree so not setting quirk bit for BDA"); - } + qcadev = serdev_device_get_drvdata(hu->serdev); + if (qcadev->bdaddr_property_broken) + set_bit(HCI_QUIRK_BDADDR_PROPERTY_BROKEN, &hdev->quirks); hci_set_aosp_capable(hdev); @@ -1961,8 +1958,10 @@ retry: qca_debugfs_init(hdev); hu->hdev->hw_error = qca_hw_error; hu->hdev->cmd_timeout = qca_cmd_timeout; - if (device_can_wakeup(hu->serdev->ctrl->dev.parent)) - hu->hdev->wakeup = qca_wakeup; + if (hu->serdev) { + if (device_can_wakeup(hu->serdev->ctrl->dev.parent)) + hu->hdev->wakeup = qca_wakeup; + } } else if (ret == -ENOENT) { /* No patch/nvm-config found, run with original fw/config */ set_bit(QCA_ROM_FW, &qca->flags); @@ -2295,6 +2294,9 @@ static int qca_serdev_probe(struct serdev_device *serdev) if (!qcadev->oper_speed) BT_DBG("UART will pick default operating speed"); + qcadev->bdaddr_property_broken = device_property_read_bool(&serdev->dev, + "qcom,local-bd-address-broken"); + if (data) qcadev->btsoc_type = data->soc_type; else @@ -2330,16 +2332,21 @@ static int qca_serdev_probe(struct serdev_device *serdev) (data->soc_type == QCA_WCN6750 || data->soc_type == QCA_WCN6855)) { dev_err(&serdev->dev, "failed to acquire BT_EN gpio\n"); - power_ctrl_enabled = false; + return PTR_ERR(qcadev->bt_en); } + if (!qcadev->bt_en) + power_ctrl_enabled = false; + qcadev->sw_ctrl = devm_gpiod_get_optional(&serdev->dev, "swctrl", GPIOD_IN); if (IS_ERR(qcadev->sw_ctrl) && (data->soc_type == QCA_WCN6750 || data->soc_type == QCA_WCN6855 || - data->soc_type == QCA_WCN7850)) - dev_warn(&serdev->dev, "failed to acquire SW_CTRL gpio\n"); + data->soc_type == QCA_WCN7850)) { + dev_err(&serdev->dev, "failed to acquire SW_CTRL gpio\n"); + return PTR_ERR(qcadev->sw_ctrl); + } qcadev->susclk = devm_clk_get_optional(&serdev->dev, NULL); if (IS_ERR(qcadev->susclk)) { @@ -2358,10 +2365,13 @@ static int qca_serdev_probe(struct serdev_device *serdev) qcadev->bt_en = devm_gpiod_get_optional(&serdev->dev, "enable", GPIOD_OUT_LOW); if (IS_ERR(qcadev->bt_en)) { - dev_warn(&serdev->dev, "failed to acquire enable gpio\n"); - power_ctrl_enabled = false; + dev_err(&serdev->dev, "failed to acquire enable gpio\n"); + return PTR_ERR(qcadev->bt_en); } + if (!qcadev->bt_en) + power_ctrl_enabled = false; + qcadev->susclk = devm_clk_get_optional(&serdev->dev, NULL); if (IS_ERR(qcadev->susclk)) { dev_warn(&serdev->dev, "failed to acquire clk\n"); |