diff options
Diffstat (limited to 'drivers/gpio')
| -rw-r--r-- | drivers/gpio/Kconfig | 7 | ||||
| -rw-r--r-- | drivers/gpio/gpio-msic.c | 314 |
2 files changed, 0 insertions, 321 deletions
diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig index c96086f15bc0..5c0d46369591 100644 --- a/drivers/gpio/Kconfig +++ b/drivers/gpio/Kconfig @@ -1256,13 +1256,6 @@ config GPIO_MAX77650 GPIO driver for MAX77650/77651 PMIC from Maxim Semiconductor. These chips have a single pin that can be configured as GPIO. -config GPIO_MSIC - bool "Intel MSIC mixed signal gpio support" - depends on (X86 || COMPILE_TEST) && MFD_INTEL_MSIC - help - Enable support for GPIO on intel MSIC controllers found in - intel MID devices - config GPIO_PALMAS bool "TI PALMAS series PMICs GPIO" depends on MFD_PALMAS diff --git a/drivers/gpio/gpio-msic.c b/drivers/gpio/gpio-msic.c deleted file mode 100644 index 7e3c96e4ab2c..000000000000 --- a/drivers/gpio/gpio-msic.c +++ /dev/null @@ -1,314 +0,0 @@ -// SPDX-License-Identifier: GPL-2.0 -/* - * Intel Medfield MSIC GPIO driver> - * Copyright (c) 2011, Intel Corporation. - * - * Author: Mathias Nyman <mathias.nyman@linux.intel.com> - * Based on intel_pmic_gpio.c - */ - -#include <linux/gpio/driver.h> -#include <linux/init.h> -#include <linux/interrupt.h> -#include <linux/kernel.h> -#include <linux/mfd/intel_msic.h> -#include <linux/platform_device.h> -#include <linux/slab.h> - -/* the offset for the mapping of global gpio pin to irq */ -#define MSIC_GPIO_IRQ_OFFSET 0x100 - -#define MSIC_GPIO_DIR_IN 0 -#define MSIC_GPIO_DIR_OUT BIT(5) -#define MSIC_GPIO_TRIG_FALL BIT(1) -#define MSIC_GPIO_TRIG_RISE BIT(2) - -/* masks for msic gpio output GPIOxxxxCTLO registers */ -#define MSIC_GPIO_DIR_MASK BIT(5) -#define MSIC_GPIO_DRV_MASK BIT(4) -#define MSIC_GPIO_REN_MASK BIT(3) -#define MSIC_GPIO_RVAL_MASK (BIT(2) | BIT(1)) -#define MSIC_GPIO_DOUT_MASK BIT(0) - -/* masks for msic gpio input GPIOxxxxCTLI registers */ -#define MSIC_GPIO_GLBYP_MASK BIT(5) -#define MSIC_GPIO_DBNC_MASK (BIT(4) | BIT(3)) -#define MSIC_GPIO_INTCNT_MASK (BIT(2) | BIT(1)) -#define MSIC_GPIO_DIN_MASK BIT(0) - -#define MSIC_NUM_GPIO 24 - -struct msic_gpio { - struct platform_device *pdev; - struct mutex buslock; - struct gpio_chip chip; - int irq; - unsigned irq_base; - unsigned long trig_change_mask; - unsigned trig_type; -}; - -/* - * MSIC has 24 gpios, 16 low voltage (1.2-1.8v) and 8 high voltage (3v). - * Both the high and low voltage gpios are divided in two banks. - * GPIOs are numbered with GPIO0LV0 as gpio_base in the following order: - * GPIO0LV0..GPIO0LV7: low voltage, bank 0, gpio_base - * GPIO1LV0..GPIO1LV7: low voltage, bank 1, gpio_base + 8 - * GPIO0HV0..GPIO0HV3: high voltage, bank 0, gpio_base + 16 - * GPIO1HV0..GPIO1HV3: high voltage, bank 1, gpio_base + 20 - */ - -static int msic_gpio_to_ireg(unsigned offset) -{ - if (offset >= MSIC_NUM_GPIO) - return -EINVAL; - - if (offset < 8) - return INTEL_MSIC_GPIO0LV0CTLI - offset; - if (offset < 16) - return INTEL_MSIC_GPIO1LV0CTLI - offset + 8; - if (offset < 20) - return INTEL_MSIC_GPIO0HV0CTLI - offset + 16; - - return INTEL_MSIC_GPIO1HV0CTLI - offset + 20; -} - -static int msic_gpio_to_oreg(unsigned offset) -{ - if (offset >= MSIC_NUM_GPIO) - return -EINVAL; - - if (offset < 8) - return INTEL_MSIC_GPIO0LV0CTLO - offset; - if (offset < 16) - return INTEL_MSIC_GPIO1LV0CTLO - offset + 8; - if (offset < 20) - return INTEL_MSIC_GPIO0HV0CTLO - offset + 16; - - return INTEL_MSIC_GPIO1HV0CTLO - offset + 20; -} - -static int msic_gpio_direction_input(struct gpio_chip *chip, unsigned offset) -{ - int reg; - - reg = msic_gpio_to_oreg(offset); - if (reg < 0) - return reg; - - return intel_msic_reg_update(reg, MSIC_GPIO_DIR_IN, MSIC_GPIO_DIR_MASK); -} - -static int msic_gpio_direction_output(struct gpio_chip *chip, - unsigned offset, int value) -{ - int reg; - unsigned mask; - - value = (!!value) | MSIC_GPIO_DIR_OUT; - mask = MSIC_GPIO_DIR_MASK | MSIC_GPIO_DOUT_MASK; - - reg = msic_gpio_to_oreg(offset); - if (reg < 0) - return reg; - - return intel_msic_reg_update(reg, value, mask); -} - -static int msic_gpio_get(struct gpio_chip *chip, unsigned offset) -{ - u8 r; - int ret; - int reg; - - reg = msic_gpio_to_ireg(offset); - if (reg < 0) - return reg; - - ret = intel_msic_reg_read(reg, &r); - if (ret < 0) - return ret; - - return !!(r & MSIC_GPIO_DIN_MASK); -} - -static void msic_gpio_set(struct gpio_chip *chip, unsigned offset, int value) -{ - int reg; - - reg = msic_gpio_to_oreg(offset); - if (reg < 0) - return; - - intel_msic_reg_update(reg, !!value , MSIC_GPIO_DOUT_MASK); -} - -/* - * This is called from genirq with mg->buslock locked and - * irq_desc->lock held. We can not access the scu bus here, so we - * store the change and update in the bus_sync_unlock() function below - */ -static int msic_irq_type(struct irq_data *data, unsigned type) -{ - struct msic_gpio *mg = irq_data_get_irq_chip_data(data); - u32 gpio = data->irq - mg->irq_base; - - if (gpio >= mg->chip.ngpio) - return -EINVAL; - - /* mark for which gpio the trigger changed, protected by buslock */ - mg->trig_change_mask |= (1 << gpio); - mg->trig_type = type; - - return 0; -} - -static int msic_gpio_to_irq(struct gpio_chip *chip, unsigned offset) -{ - struct msic_gpio *mg = gpiochip_get_data(chip); - return mg->irq_base + offset; -} - -static void msic_bus_lock(struct irq_data *data) -{ - struct msic_gpio *mg = irq_data_get_irq_chip_data(data); - mutex_lock(&mg->buslock); -} - -static void msic_bus_sync_unlock(struct irq_data *data) -{ - struct msic_gpio *mg = irq_data_get_irq_chip_data(data); - int offset; - int reg; - u8 trig = 0; - - /* We can only get one change at a time as the buslock covers the - entire transaction. The irq_desc->lock is dropped before we are - called but that is fine */ - if (mg->trig_change_mask) { - offset = __ffs(mg->trig_change_mask); - - reg = msic_gpio_to_ireg(offset); - if (reg < 0) - goto out; - - if (mg->trig_type & IRQ_TYPE_EDGE_RISING) - trig |= MSIC_GPIO_TRIG_RISE; - if (mg->trig_type & IRQ_TYPE_EDGE_FALLING) - trig |= MSIC_GPIO_TRIG_FALL; - - intel_msic_reg_update(reg, trig, MSIC_GPIO_INTCNT_MASK); - mg->trig_change_mask = 0; - } -out: - mutex_unlock(&mg->buslock); -} - -/* Firmware does all the masking and unmasking for us, no masking here. */ -static void msic_irq_unmask(struct irq_data *data) { } - -static void msic_irq_mask(struct irq_data *data) { } - -static struct irq_chip msic_irqchip = { - .name = "MSIC-GPIO", - .irq_mask = msic_irq_mask, - .irq_unmask = msic_irq_unmask, - .irq_set_type = msic_irq_type, - .irq_bus_lock = msic_bus_lock, - .irq_bus_sync_unlock = msic_bus_sync_unlock, -}; - -static void msic_gpio_irq_handler(struct irq_desc *desc) -{ - struct irq_data *data = irq_desc_get_irq_data(desc); - struct msic_gpio *mg = irq_data_get_irq_handler_data(data); - struct irq_chip *chip = irq_data_get_irq_chip(data); - struct intel_msic *msic = pdev_to_intel_msic(mg->pdev); - unsigned long pending; - int i; - int bitnr; - u8 pin; - - for (i = 0; i < (mg->chip.ngpio / BITS_PER_BYTE); i++) { - intel_msic_irq_read(msic, INTEL_MSIC_GPIO0LVIRQ + i, &pin); - pending = pin; - - for_each_set_bit(bitnr, &pending, BITS_PER_BYTE) - generic_handle_irq(mg->irq_base + i * BITS_PER_BYTE + bitnr); - } - chip->irq_eoi(data); -} - -static int platform_msic_gpio_probe(struct platform_device *pdev) -{ - struct device *dev = &pdev->dev; - struct intel_msic_gpio_pdata *pdata = dev_get_platdata(dev); - struct msic_gpio *mg; - int irq = platform_get_irq(pdev, 0); - int retval; - int i; - - if (irq < 0) { - dev_err(dev, "no IRQ line: %d\n", irq); - return irq; - } - - if (!pdata || !pdata->gpio_base) { - dev_err(dev, "incorrect or missing platform data\n"); - return -EINVAL; - } - - mg = kzalloc(sizeof(*mg), GFP_KERNEL); - if (!mg) - return -ENOMEM; - - dev_set_drvdata(dev, mg); - - mg->pdev = pdev; - mg->irq = irq; - mg->irq_base = pdata->gpio_base + MSIC_GPIO_IRQ_OFFSET; - mg->chip.label = "msic_gpio"; - mg->chip.direction_input = msic_gpio_direction_input; - mg->chip.direction_output = msic_gpio_direction_output; - mg->chip.get = msic_gpio_get; - mg->chip.set = msic_gpio_set; - mg->chip.to_irq = msic_gpio_to_irq; - mg->chip.base = pdata->gpio_base; - mg->chip.ngpio = MSIC_NUM_GPIO; - mg->chip.can_sleep = true; - mg->chip.parent = dev; - - mutex_init(&mg->buslock); - - retval = gpiochip_add_data(&mg->chip, mg); - if (retval) { - dev_err(dev, "Adding MSIC gpio chip failed\n"); - goto err; - } - - for (i = 0; i < mg->chip.ngpio; i++) { - irq_set_chip_data(i + mg->irq_base, mg); - irq_set_chip_and_handler(i + mg->irq_base, - &msic_irqchip, - handle_simple_irq); - } - irq_set_chained_handler_and_data(mg->irq, msic_gpio_irq_handler, mg); - - return 0; -err: - kfree(mg); - return retval; -} - -static struct platform_driver platform_msic_gpio_driver = { - .driver = { - .name = "msic_gpio", - }, - .probe = platform_msic_gpio_probe, -}; - -static int __init platform_msic_gpio_init(void) -{ - return platform_driver_register(&platform_msic_gpio_driver); -} -subsys_initcall(platform_msic_gpio_init); |