diff options
Diffstat (limited to 'drivers/net/phy/bcm7xxx.c')
-rw-r--r-- | drivers/net/phy/bcm7xxx.c | 76 |
1 files changed, 4 insertions, 72 deletions
diff --git a/drivers/net/phy/bcm7xxx.c b/drivers/net/phy/bcm7xxx.c index b8415f8fae14..a75e1b283541 100644 --- a/drivers/net/phy/bcm7xxx.c +++ b/drivers/net/phy/bcm7xxx.c @@ -37,77 +37,10 @@ #define MII_BCM7XXX_SHD_3_TL4 0x23 #define MII_BCM7XXX_TL4_RST_MSK (BIT(2) | BIT(1)) -/* 28nm only register definitions */ -#define MISC_ADDR(base, channel) base, channel - -#define DSP_TAP10 MISC_ADDR(0x0a, 0) -#define PLL_PLLCTRL_1 MISC_ADDR(0x32, 1) -#define PLL_PLLCTRL_2 MISC_ADDR(0x32, 2) -#define PLL_PLLCTRL_4 MISC_ADDR(0x33, 0) - -#define AFE_RXCONFIG_0 MISC_ADDR(0x38, 0) -#define AFE_RXCONFIG_1 MISC_ADDR(0x38, 1) -#define AFE_RXCONFIG_2 MISC_ADDR(0x38, 2) -#define AFE_RX_LP_COUNTER MISC_ADDR(0x38, 3) -#define AFE_TX_CONFIG MISC_ADDR(0x39, 0) -#define AFE_VDCA_ICTRL_0 MISC_ADDR(0x39, 1) -#define AFE_VDAC_OTHERS_0 MISC_ADDR(0x39, 3) -#define AFE_HPF_TRIM_OTHERS MISC_ADDR(0x3a, 0) - struct bcm7xxx_phy_priv { u64 *stats; }; -static void r_rc_cal_reset(struct phy_device *phydev) -{ - /* Reset R_CAL/RC_CAL Engine */ - bcm_phy_write_exp_sel(phydev, 0x00b0, 0x0010); - - /* Disable Reset R_AL/RC_CAL Engine */ - bcm_phy_write_exp_sel(phydev, 0x00b0, 0x0000); -} - -static int bcm7xxx_28nm_b0_afe_config_init(struct phy_device *phydev) -{ - /* Increase VCO range to prevent unlocking problem of PLL at low - * temp - */ - bcm_phy_write_misc(phydev, PLL_PLLCTRL_1, 0x0048); - - /* Change Ki to 011 */ - bcm_phy_write_misc(phydev, PLL_PLLCTRL_2, 0x021b); - - /* Disable loading of TVCO buffer to bandgap, set bandgap trim - * to 111 - */ - bcm_phy_write_misc(phydev, PLL_PLLCTRL_4, 0x0e20); - - /* Adjust bias current trim by -3 */ - bcm_phy_write_misc(phydev, DSP_TAP10, 0x690b); - - /* Switch to CORE_BASE1E */ - phy_write(phydev, MII_BRCM_CORE_BASE1E, 0xd); - - r_rc_cal_reset(phydev); - - /* write AFE_RXCONFIG_0 */ - bcm_phy_write_misc(phydev, AFE_RXCONFIG_0, 0xeb19); - - /* write AFE_RXCONFIG_1 */ - bcm_phy_write_misc(phydev, AFE_RXCONFIG_1, 0x9a3f); - - /* write AFE_RX_LP_COUNTER */ - bcm_phy_write_misc(phydev, AFE_RX_LP_COUNTER, 0x7fc0); - - /* write AFE_HPF_TRIM_OTHERS */ - bcm_phy_write_misc(phydev, AFE_HPF_TRIM_OTHERS, 0x000b); - - /* write AFTE_TX_CONFIG */ - bcm_phy_write_misc(phydev, AFE_TX_CONFIG, 0x0800); - - return 0; -} - static int bcm7xxx_28nm_d0_afe_config_init(struct phy_device *phydev) { /* AFE_RXCONFIG_0 */ @@ -143,7 +76,7 @@ static int bcm7xxx_28nm_d0_afe_config_init(struct phy_device *phydev) bcm_phy_write_misc(phydev, DSP_TAP10, 0x011b); /* Reset R_CAL/RC_CAL engine */ - r_rc_cal_reset(phydev); + bcm_phy_r_rc_cal_reset(phydev); return 0; } @@ -171,7 +104,7 @@ static int bcm7xxx_28nm_e0_plus_afe_config_init(struct phy_device *phydev) bcm_phy_write_misc(phydev, DSP_TAP10, 0x011b); /* Reset R_CAL/RC_CAL engine */ - r_rc_cal_reset(phydev); + bcm_phy_r_rc_cal_reset(phydev); return 0; } @@ -196,7 +129,7 @@ static int bcm7xxx_28nm_a0_patch_afe_config_init(struct phy_device *phydev) /* Enable ffe zero detection for Vitesse interoperability */ bcm_phy_write_misc(phydev, 0x26, 0x2, 0x0015); - r_rc_cal_reset(phydev); + bcm_phy_r_rc_cal_reset(phydev); return 0; } @@ -227,7 +160,7 @@ static int bcm7xxx_28nm_config_init(struct phy_device *phydev) switch (rev) { case 0xa0: case 0xb0: - ret = bcm7xxx_28nm_b0_afe_config_init(phydev); + ret = bcm_phy_28nm_a0b0_afe_config_init(phydev); break; case 0xd0: ret = bcm7xxx_28nm_d0_afe_config_init(phydev); @@ -657,7 +590,6 @@ static struct phy_driver bcm7xxx_driver[] = { BCM7XXX_28NM_GPHY(PHY_ID_BCM7439, "Broadcom BCM7439"), BCM7XXX_28NM_GPHY(PHY_ID_BCM7439_2, "Broadcom BCM7439 (2)"), BCM7XXX_28NM_GPHY(PHY_ID_BCM7445, "Broadcom BCM7445"), - BCM7XXX_28NM_GPHY(PHY_ID_BCM_OMEGA, "Broadcom Omega Combo GPHY"), BCM7XXX_40NM_EPHY(PHY_ID_BCM7346, "Broadcom BCM7346"), BCM7XXX_40NM_EPHY(PHY_ID_BCM7362, "Broadcom BCM7362"), BCM7XXX_40NM_EPHY(PHY_ID_BCM7425, "Broadcom BCM7425"), |