diff options
Diffstat (limited to 'drivers/usb/musb/musb_gadget.c')
| -rw-r--r-- | drivers/usb/musb/musb_gadget.c | 82 |
1 files changed, 53 insertions, 29 deletions
diff --git a/drivers/usb/musb/musb_gadget.c b/drivers/usb/musb/musb_gadget.c index b67a062f556b..ae4a20acef6c 100644 --- a/drivers/usb/musb/musb_gadget.c +++ b/drivers/usb/musb/musb_gadget.c @@ -634,6 +634,7 @@ static void rxstate(struct musb *musb, struct musb_request *req) u16 len; u16 csr = musb_readw(epio, MUSB_RXCSR); struct musb_hw_ep *hw_ep = &musb->endpoints[epnum]; + u8 use_mode_1; if (hw_ep->is_shared_fifo) musb_ep = &hw_ep->ep_in; @@ -683,6 +684,18 @@ static void rxstate(struct musb *musb, struct musb_request *req) if (csr & MUSB_RXCSR_RXPKTRDY) { len = musb_readw(epio, MUSB_RXCOUNT); + + /* + * Enable Mode 1 on RX transfers only when short_not_ok flag + * is set. Currently short_not_ok flag is set only from + * file_storage and f_mass_storage drivers + */ + + if (request->short_not_ok && len == musb_ep->packet_sz) + use_mode_1 = 1; + else + use_mode_1 = 0; + if (request->actual < request->length) { #ifdef CONFIG_USB_INVENTRA_DMA if (is_buffer_mapped(req)) { @@ -704,7 +717,7 @@ static void rxstate(struct musb *musb, struct musb_request *req) * most these gadgets, end of is signified either by a short packet, * or filling the last byte of the buffer. (Sending extra data in * that last pckate should trigger an overflow fault.) But in mode 1, - * we don't get DMA completion interrrupt for short packets. + * we don't get DMA completion interrupt for short packets. * * Theoretically, we could enable DMAReq irq (MUSB_RXCSR_DMAMODE = 1), * to get endpoint interrupt on every DMA req, but that didn't seem @@ -714,37 +727,41 @@ static void rxstate(struct musb *musb, struct musb_request *req) * then becomes usable as a runtime "use mode 1" hint... */ - csr |= MUSB_RXCSR_DMAENAB; -#ifdef USE_MODE1 - csr |= MUSB_RXCSR_AUTOCLEAR; - /* csr |= MUSB_RXCSR_DMAMODE; */ - - /* this special sequence (enabling and then - * disabling MUSB_RXCSR_DMAMODE) is required - * to get DMAReq to activate - */ - musb_writew(epio, MUSB_RXCSR, - csr | MUSB_RXCSR_DMAMODE); -#else - if (!musb_ep->hb_mult && - musb_ep->hw_ep->rx_double_buffered) + /* Experimental: Mode1 works with mass storage use cases */ + if (use_mode_1) { csr |= MUSB_RXCSR_AUTOCLEAR; -#endif - musb_writew(epio, MUSB_RXCSR, csr); + musb_writew(epio, MUSB_RXCSR, csr); + csr |= MUSB_RXCSR_DMAENAB; + musb_writew(epio, MUSB_RXCSR, csr); + + /* + * this special sequence (enabling and then + * disabling MUSB_RXCSR_DMAMODE) is required + * to get DMAReq to activate + */ + musb_writew(epio, MUSB_RXCSR, + csr | MUSB_RXCSR_DMAMODE); + musb_writew(epio, MUSB_RXCSR, csr); + + } else { + if (!musb_ep->hb_mult && + musb_ep->hw_ep->rx_double_buffered) + csr |= MUSB_RXCSR_AUTOCLEAR; + csr |= MUSB_RXCSR_DMAENAB; + musb_writew(epio, MUSB_RXCSR, csr); + } if (request->actual < request->length) { int transfer_size = 0; -#ifdef USE_MODE1 - transfer_size = min(request->length - request->actual, - channel->max_len); -#else - transfer_size = min(request->length - request->actual, - (unsigned)len); -#endif - if (transfer_size <= musb_ep->packet_sz) - musb_ep->dma->desired_mode = 0; - else + if (use_mode_1) { + transfer_size = min(request->length - request->actual, + channel->max_len); musb_ep->dma->desired_mode = 1; + } else { + transfer_size = min(request->length - request->actual, + (unsigned)len); + musb_ep->dma->desired_mode = 0; + } use_dma = c->channel_program( channel, @@ -1020,7 +1037,7 @@ static int musb_gadget_enable(struct usb_ep *ep, goto fail; /* REVISIT this rules out high bandwidth periodic transfers */ - tmp = le16_to_cpu(desc->wMaxPacketSize); + tmp = usb_endpoint_maxp(desc); if (tmp & ~0x07ff) { int ok; @@ -1698,6 +1715,8 @@ static int musb_gadget_pullup(struct usb_gadget *gadget, int is_on) is_on = !!is_on; + pm_runtime_get_sync(musb->controller); + /* NOTE: this assumes we are sensing vbus; we'd rather * not pullup unless the B-session is active. */ @@ -1707,6 +1726,9 @@ static int musb_gadget_pullup(struct usb_gadget *gadget, int is_on) musb_pullup(musb, is_on); } spin_unlock_irqrestore(&musb->lock, flags); + + pm_runtime_put(musb->controller); + return 0; } @@ -1851,6 +1873,7 @@ int __init musb_gadget_setup(struct musb *musb) return 0; err: + musb->g.dev.parent = NULL; device_unregister(&musb->g.dev); return status; } @@ -1858,7 +1881,8 @@ err: void musb_gadget_cleanup(struct musb *musb) { usb_del_gadget_udc(&musb->g); - device_unregister(&musb->g.dev); + if (musb->g.dev.parent) + device_unregister(&musb->g.dev); } /* |