diff options
Diffstat (limited to 'drivers')
-rw-r--r-- | drivers/md/raid10.c | 245 |
1 files changed, 140 insertions, 105 deletions
diff --git a/drivers/md/raid10.c b/drivers/md/raid10.c index ab5e86209322..1920756828df 100644 --- a/drivers/md/raid10.c +++ b/drivers/md/raid10.c @@ -1087,23 +1087,122 @@ static void raid10_unplug(struct blk_plug_cb *cb, bool from_schedule) kfree(plug); } -static void __make_request(struct mddev *mddev, struct bio *bio) +static void raid10_read_request(struct mddev *mddev, struct bio *bio, + struct r10bio *r10_bio) { struct r10conf *conf = mddev->private; - struct r10bio *r10_bio; struct bio *read_bio; + const int op = bio_op(bio); + const unsigned long do_sync = (bio->bi_opf & REQ_SYNC); + int sectors_handled; + int max_sectors; + sector_t sectors; + struct md_rdev *rdev; + int slot; + + /* + * Register the new request and wait if the reconstruction + * thread has put up a bar for new requests. + * Continue immediately if no resync is active currently. + */ + wait_barrier(conf); + + sectors = bio_sectors(bio); + while (test_bit(MD_RECOVERY_RESHAPE, &mddev->recovery) && + bio->bi_iter.bi_sector < conf->reshape_progress && + bio->bi_iter.bi_sector + sectors > conf->reshape_progress) { + /* + * IO spans the reshape position. Need to wait for reshape to + * pass + */ + raid10_log(conf->mddev, "wait reshape"); + allow_barrier(conf); + wait_event(conf->wait_barrier, + conf->reshape_progress <= bio->bi_iter.bi_sector || + conf->reshape_progress >= bio->bi_iter.bi_sector + + sectors); + wait_barrier(conf); + } + +read_again: + rdev = read_balance(conf, r10_bio, &max_sectors); + if (!rdev) { + raid_end_bio_io(r10_bio); + return; + } + slot = r10_bio->read_slot; + + read_bio = bio_clone_mddev(bio, GFP_NOIO, mddev); + bio_trim(read_bio, r10_bio->sector - bio->bi_iter.bi_sector, + max_sectors); + + r10_bio->devs[slot].bio = read_bio; + r10_bio->devs[slot].rdev = rdev; + + read_bio->bi_iter.bi_sector = r10_bio->devs[slot].addr + + choose_data_offset(r10_bio, rdev); + read_bio->bi_bdev = rdev->bdev; + read_bio->bi_end_io = raid10_end_read_request; + bio_set_op_attrs(read_bio, op, do_sync); + if (test_bit(FailFast, &rdev->flags) && + test_bit(R10BIO_FailFast, &r10_bio->state)) + read_bio->bi_opf |= MD_FAILFAST; + read_bio->bi_private = r10_bio; + + if (mddev->gendisk) + trace_block_bio_remap(bdev_get_queue(read_bio->bi_bdev), + read_bio, disk_devt(mddev->gendisk), + r10_bio->sector); + if (max_sectors < r10_bio->sectors) { + /* + * Could not read all from this device, so we will need another + * r10_bio. + */ + sectors_handled = (r10_bio->sector + max_sectors + - bio->bi_iter.bi_sector); + r10_bio->sectors = max_sectors; + spin_lock_irq(&conf->device_lock); + if (bio->bi_phys_segments == 0) + bio->bi_phys_segments = 2; + else + bio->bi_phys_segments++; + spin_unlock_irq(&conf->device_lock); + /* + * Cannot call generic_make_request directly as that will be + * queued in __generic_make_request and subsequent + * mempool_alloc might block waiting for it. so hand bio over + * to raid10d. + */ + reschedule_retry(r10_bio); + + r10_bio = mempool_alloc(conf->r10bio_pool, GFP_NOIO); + + r10_bio->master_bio = bio; + r10_bio->sectors = bio_sectors(bio) - sectors_handled; + r10_bio->state = 0; + r10_bio->mddev = mddev; + r10_bio->sector = bio->bi_iter.bi_sector + sectors_handled; + goto read_again; + } else + generic_make_request(read_bio); + return; +} + +static void raid10_write_request(struct mddev *mddev, struct bio *bio, + struct r10bio *r10_bio) +{ + struct r10conf *conf = mddev->private; int i; const int op = bio_op(bio); - const int rw = bio_data_dir(bio); const unsigned long do_sync = (bio->bi_opf & REQ_SYNC); const unsigned long do_fua = (bio->bi_opf & REQ_FUA); unsigned long flags; struct md_rdev *blocked_rdev; struct blk_plug_cb *cb; struct raid10_plug_cb *plug = NULL; + sector_t sectors; int sectors_handled; int max_sectors; - int sectors; md_write_start(mddev, bio); @@ -1118,8 +1217,9 @@ static void __make_request(struct mddev *mddev, struct bio *bio) while (test_bit(MD_RECOVERY_RESHAPE, &mddev->recovery) && bio->bi_iter.bi_sector < conf->reshape_progress && bio->bi_iter.bi_sector + sectors > conf->reshape_progress) { - /* IO spans the reshape position. Need to wait for - * reshape to pass + /* + * IO spans the reshape position. Need to wait for reshape to + * pass */ raid10_log(conf->mddev, "wait reshape"); allow_barrier(conf); @@ -1129,8 +1229,8 @@ static void __make_request(struct mddev *mddev, struct bio *bio) sectors); wait_barrier(conf); } + if (test_bit(MD_RECOVERY_RESHAPE, &mddev->recovery) && - bio_data_dir(bio) == WRITE && (mddev->reshape_backwards ? (bio->bi_iter.bi_sector < conf->reshape_safe && bio->bi_iter.bi_sector + sectors > conf->reshape_progress) @@ -1148,98 +1248,6 @@ static void __make_request(struct mddev *mddev, struct bio *bio) conf->reshape_safe = mddev->reshape_position; } - r10_bio = mempool_alloc(conf->r10bio_pool, GFP_NOIO); - - r10_bio->master_bio = bio; - r10_bio->sectors = sectors; - - r10_bio->mddev = mddev; - r10_bio->sector = bio->bi_iter.bi_sector; - r10_bio->state = 0; - - /* We might need to issue multiple reads to different - * devices if there are bad blocks around, so we keep - * track of the number of reads in bio->bi_phys_segments. - * If this is 0, there is only one r10_bio and no locking - * will be needed when the request completes. If it is - * non-zero, then it is the number of not-completed requests. - */ - bio->bi_phys_segments = 0; - bio_clear_flag(bio, BIO_SEG_VALID); - - if (rw == READ) { - /* - * read balancing logic: - */ - struct md_rdev *rdev; - int slot; - -read_again: - rdev = read_balance(conf, r10_bio, &max_sectors); - if (!rdev) { - raid_end_bio_io(r10_bio); - return; - } - slot = r10_bio->read_slot; - - read_bio = bio_clone_mddev(bio, GFP_NOIO, mddev); - bio_trim(read_bio, r10_bio->sector - bio->bi_iter.bi_sector, - max_sectors); - - r10_bio->devs[slot].bio = read_bio; - r10_bio->devs[slot].rdev = rdev; - - read_bio->bi_iter.bi_sector = r10_bio->devs[slot].addr + - choose_data_offset(r10_bio, rdev); - read_bio->bi_bdev = rdev->bdev; - read_bio->bi_end_io = raid10_end_read_request; - bio_set_op_attrs(read_bio, op, do_sync); - if (test_bit(FailFast, &rdev->flags) && - test_bit(R10BIO_FailFast, &r10_bio->state)) - read_bio->bi_opf |= MD_FAILFAST; - read_bio->bi_private = r10_bio; - - if (mddev->gendisk) - trace_block_bio_remap(bdev_get_queue(read_bio->bi_bdev), - read_bio, disk_devt(mddev->gendisk), - r10_bio->sector); - if (max_sectors < r10_bio->sectors) { - /* Could not read all from this device, so we will - * need another r10_bio. - */ - sectors_handled = (r10_bio->sector + max_sectors - - bio->bi_iter.bi_sector); - r10_bio->sectors = max_sectors; - spin_lock_irq(&conf->device_lock); - if (bio->bi_phys_segments == 0) - bio->bi_phys_segments = 2; - else - bio->bi_phys_segments++; - spin_unlock_irq(&conf->device_lock); - /* Cannot call generic_make_request directly - * as that will be queued in __generic_make_request - * and subsequent mempool_alloc might block - * waiting for it. so hand bio over to raid10d. - */ - reschedule_retry(r10_bio); - - r10_bio = mempool_alloc(conf->r10bio_pool, GFP_NOIO); - - r10_bio->master_bio = bio; - r10_bio->sectors = bio_sectors(bio) - sectors_handled; - r10_bio->state = 0; - r10_bio->mddev = mddev; - r10_bio->sector = bio->bi_iter.bi_sector + - sectors_handled; - goto read_again; - } else - generic_make_request(read_bio); - return; - } - - /* - * WRITE: - */ if (conf->pending_count >= max_queued_requests) { md_wakeup_thread(mddev->thread); raid10_log(mddev, "wait queued"); @@ -1300,8 +1308,7 @@ retry_write: int bad_sectors; int is_bad; - is_bad = is_badblock(rdev, dev_sector, - max_sectors, + is_bad = is_badblock(rdev, dev_sector, max_sectors, &first_bad, &bad_sectors); if (is_bad < 0) { /* Mustn't write here until the bad block @@ -1405,8 +1412,7 @@ retry_write: r10_bio->devs[i].bio = mbio; mbio->bi_iter.bi_sector = (r10_bio->devs[i].addr+ - choose_data_offset(r10_bio, - rdev)); + choose_data_offset(r10_bio, rdev)); mbio->bi_bdev = rdev->bdev; mbio->bi_end_io = raid10_end_write_request; bio_set_op_attrs(mbio, op, do_sync | do_fua); @@ -1457,8 +1463,7 @@ retry_write: r10_bio->devs[i].repl_bio = mbio; mbio->bi_iter.bi_sector = (r10_bio->devs[i].addr + - choose_data_offset( - r10_bio, rdev)); + choose_data_offset(r10_bio, rdev)); mbio->bi_bdev = rdev->bdev; mbio->bi_end_io = raid10_end_write_request; bio_set_op_attrs(mbio, op, do_sync | do_fua); @@ -1503,6 +1508,36 @@ retry_write: one_write_done(r10_bio); } +static void __make_request(struct mddev *mddev, struct bio *bio) +{ + struct r10conf *conf = mddev->private; + struct r10bio *r10_bio; + + r10_bio = mempool_alloc(conf->r10bio_pool, GFP_NOIO); + + r10_bio->master_bio = bio; + r10_bio->sectors = bio_sectors(bio); + + r10_bio->mddev = mddev; + r10_bio->sector = bio->bi_iter.bi_sector; + r10_bio->state = 0; + + /* + * We might need to issue multiple reads to different devices if there + * are bad blocks around, so we keep track of the number of reads in + * bio->bi_phys_segments. If this is 0, there is only one r10_bio and + * no locking will be needed when the request completes. If it is + * non-zero, then it is the number of not-completed requests. + */ + bio->bi_phys_segments = 0; + bio_clear_flag(bio, BIO_SEG_VALID); + + if (bio_data_dir(bio) == READ) + raid10_read_request(mddev, bio, r10_bio); + else + raid10_write_request(mddev, bio, r10_bio); +} + static void raid10_make_request(struct mddev *mddev, struct bio *bio) { struct r10conf *conf = mddev->private; |