diff options
Diffstat (limited to 'include/linux/regmap.h')
| -rw-r--r-- | include/linux/regmap.h | 18 |
1 files changed, 12 insertions, 6 deletions
diff --git a/include/linux/regmap.h b/include/linux/regmap.h index 791c15ad1f63..c9a9bbbb6261 100644 --- a/include/linux/regmap.h +++ b/include/linux/regmap.h @@ -1473,8 +1473,10 @@ struct regmap_irq_sub_irq_map { * @ack_base: Base ack address. If zero then the chip is clear on read. * Using zero value is possible with @use_ack bit. * @wake_base: Base address for wake enables. If zero unsupported. - * @type_base: Base address for irq type. If zero unsupported. - * @virt_reg_base: Base addresses for extra config regs. + * @type_base: Base address for irq type. If zero unsupported. Deprecated, + * use @config_base instead. + * @virt_reg_base: Base addresses for extra config regs. Deprecated, use + * @config_base instead. * @config_base: Base address for IRQ type config regs. If null unsupported. * @irq_reg_stride: Stride to use for chips where registers are not contiguous. * @init_ack_masked: Ack all masked interrupts once during initalization. @@ -1483,7 +1485,8 @@ struct regmap_irq_sub_irq_map { * @ack_invert: Inverted ack register: cleared bits for ack. * @clear_ack: Use this to set 1 and 0 or vice-versa to clear interrupts. * @wake_invert: Inverted wake register: cleared bits are wake enabled. - * @type_invert: Invert the type flags. + * @type_invert: Invert the type flags. Deprecated, use config registers + * instead. * @type_in_mask: Use the mask registers for controlling irq type. Use this if * the hardware provides separate bits for rising/falling edge * or low/high level interrupts and they should be combined into @@ -1502,9 +1505,11 @@ struct regmap_irq_sub_irq_map { * @irqs: Descriptors for individual IRQs. Interrupt numbers are * assigned based on the index in the array of the interrupt. * @num_irqs: Number of descriptors. - * @num_type_reg: Number of type registers. + * @num_type_reg: Number of type registers. Deprecated, use config registers + * instead. * @num_virt_regs: Number of non-standard irq configuration registers. - * If zero unsupported. + * If zero unsupported. Deprecated, use config registers + * instead. * @num_config_bases: Number of config base registers. * @num_config_regs: Number of config registers for each config base register. * @handle_pre_irq: Driver specific callback to handle interrupt from device @@ -1512,7 +1517,8 @@ struct regmap_irq_sub_irq_map { * @handle_post_irq: Driver specific callback to handle interrupt from device * after handling the interrupts in regmap_irq_handler(). * @set_type_virt: Driver specific callback to extend regmap_irq_set_type() - * and configure virt regs. + * and configure virt regs. Deprecated, use @set_type_config + * callback and config registers instead. * @set_type_config: Callback used for configuring irq types. * @irq_drv_data: Driver specific IRQ data which is passed as parameter when * driver specific pre/post interrupt handler is called. |