From 0d82fb1127fb7cc8287614eb0992acb0583bc323 Mon Sep 17 00:00:00 2001 From: Sander Vanheule Date: Tue, 30 Mar 2021 19:48:43 +0200 Subject: gpio: Add Realtek Otto GPIO support Realtek MIPS SoCs (platform name Otto) have GPIO controllers with up to 64 GPIOs, divided over two banks. Each bank has a set of registers for 32 GPIOs, with support for edge-triggered interrupts. Each GPIO bank consists of four 8-bit GPIO ports (ABCD and EFGH). Most registers pack one bit per GPIO, except for the IMR register, which packs two bits per GPIO (AB-CD). Although the byte order is currently assumed to have port A..D at offset 0x0..0x3, this has been observed to be reversed on other, Lexra-based, SoCs (e.g. RTL8196E/97D/97F). Interrupt support is disabled for the fallback devicetree-compatible 'realtek,otto-gpio'. This allows for quick support of GPIO banks in which the byte order would be unknown. In this case, the port ordering in the IMR registers may not match the reversed order in the other registers (DCBA, and BA-DC or DC-BA). Signed-off-by: Sander Vanheule Reviewed-by: Linus Walleij Reviewed-by: Andy Shevchenko Signed-off-by: Bartosz Golaszewski --- drivers/gpio/Makefile | 1 + 1 file changed, 1 insertion(+) (limited to 'drivers/gpio/Makefile') diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile index c58a90a3c3b1..8ace5934e3c3 100644 --- a/drivers/gpio/Makefile +++ b/drivers/gpio/Makefile @@ -124,6 +124,7 @@ obj-$(CONFIG_GPIO_RC5T583) += gpio-rc5t583.o obj-$(CONFIG_GPIO_RCAR) += gpio-rcar.o obj-$(CONFIG_GPIO_RDA) += gpio-rda.o obj-$(CONFIG_GPIO_RDC321X) += gpio-rdc321x.o +obj-$(CONFIG_GPIO_REALTEK_OTTO) += gpio-realtek-otto.o obj-$(CONFIG_GPIO_REG) += gpio-reg.o obj-$(CONFIG_ARCH_SA1100) += gpio-sa1100.o obj-$(CONFIG_GPIO_SAMA5D2_PIOBU) += gpio-sama5d2-piobu.o -- cgit v1.2.3