From 74984a1904b3768625ef45032643f1dc2b21eb31 Mon Sep 17 00:00:00 2001 From: Alex Marginean Date: Thu, 16 Jan 2020 20:19:33 +0200 Subject: net: dsa: felix: Allow PHY to AN 10/100/1000 with 2500 serdes link If the serdes link is set to 2500 using interfce type 2500base-X, lower link speeds over on the line side should still be supported. Rate adaptation is done out of band, in our case using AQR PHYs this is done using flow control. Signed-off-by: Alex Marginean Signed-off-by: Vladimir Oltean Signed-off-by: David S. Miller --- drivers/net/dsa/ocelot/felix.c | 9 ++++----- 1 file changed, 4 insertions(+), 5 deletions(-) (limited to 'drivers/net/dsa') diff --git a/drivers/net/dsa/ocelot/felix.c b/drivers/net/dsa/ocelot/felix.c index 8a38290c29fd..3257962c147e 100644 --- a/drivers/net/dsa/ocelot/felix.c +++ b/drivers/net/dsa/ocelot/felix.c @@ -172,11 +172,10 @@ static void felix_phylink_validate(struct dsa_switch *ds, int port, phylink_set(mask, Autoneg); phylink_set(mask, Pause); phylink_set(mask, Asym_Pause); - if (state->interface != PHY_INTERFACE_MODE_2500BASEX) { - phylink_set(mask, 10baseT_Full); - phylink_set(mask, 100baseT_Full); - phylink_set(mask, 1000baseT_Full); - } + phylink_set(mask, 10baseT_Full); + phylink_set(mask, 100baseT_Full); + phylink_set(mask, 1000baseT_Full); + /* The internal ports that run at 2.5G are overclocked GMII */ if (state->interface == PHY_INTERFACE_MODE_GMII || state->interface == PHY_INTERFACE_MODE_2500BASEX || -- cgit v1.2.3