diff options
-rw-r--r-- | drivers/spi/spi-imx.c | 16 |
1 files changed, 15 insertions, 1 deletions
diff --git a/drivers/spi/spi-imx.c b/drivers/spi/spi-imx.c index 4aee3db6d6df..2872993550bd 100644 --- a/drivers/spi/spi-imx.c +++ b/drivers/spi/spi-imx.c @@ -505,7 +505,9 @@ static int mx51_ecspi_prepare_message(struct spi_imx_data *spi_imx, struct spi_message *msg) { struct spi_device *spi = msg->spi; + struct spi_transfer *xfer; u32 ctrl = MX51_ECSPI_CTRL_ENABLE; + u32 min_speed_hz = ~0U; u32 testreg, delay; u32 cfg = readl(spi_imx->base + MX51_ECSPI_CONFIG); @@ -577,8 +579,20 @@ static int mx51_ecspi_prepare_message(struct spi_imx_data *spi_imx, * be asserted before the SCLK polarity changes, which would disrupt * the SPI communication as the device on the other end would consider * the change of SCLK polarity as a clock tick already. + * + * Because spi_imx->spi_bus_clk is only set in bitbang prepare_message + * callback, iterate over all the transfers in spi_message, find the + * one with lowest bus frequency, and use that bus frequency for the + * delay calculation. In case all transfers have speed_hz == 0, then + * min_speed_hz is ~0 and the resulting delay is zero. */ - delay = (2 * 1000000) / spi_imx->spi_bus_clk; + list_for_each_entry(xfer, &msg->transfers, transfer_list) { + if (!xfer->speed_hz) + continue; + min_speed_hz = min(xfer->speed_hz, min_speed_hz); + } + + delay = (2 * 1000000) / min_speed_hz; if (likely(delay < 10)) /* SCLK is faster than 100 kHz */ udelay(delay); else /* SCLK is _very_ slow */ |