diff options
Diffstat (limited to 'drivers/regulator')
| -rw-r--r-- | drivers/regulator/max77802.c | 156 |
1 files changed, 114 insertions, 42 deletions
diff --git a/drivers/regulator/max77802.c b/drivers/regulator/max77802.c index d89792b084e9..d076df1d2166 100644 --- a/drivers/regulator/max77802.c +++ b/drivers/regulator/max77802.c @@ -33,6 +33,7 @@ #include <linux/regulator/of_regulator.h> #include <linux/mfd/max77686.h> #include <linux/mfd/max77686-private.h> +#include <dt-bindings/regulator/maxim,max77802.h> /* Default ramp delay in case it is not manually set */ #define MAX77802_RAMP_DELAY 100000 /* uV/us */ @@ -49,6 +50,10 @@ #define MAX77802_RAMP_RATE_MASK_4BIT 0xF0 #define MAX77802_RAMP_RATE_SHIFT_4BIT 4 +#define MAX77802_STATUS_OFF 0x0 +#define MAX77802_OFF_PWRREQ 0x1 +#define MAX77802_LP_PWRREQ 0x2 + /* MAX77802 has two register formats: 2-bit and 4-bit */ static const unsigned int ramp_table_77802_2bit[] = { 12500, @@ -68,6 +73,12 @@ struct max77802_regulator_prv { unsigned int opmode[MAX77802_REG_MAX]; }; +static inline unsigned int max77802_map_mode(unsigned int mode) +{ + return mode == MAX77802_OPMODE_NORMAL ? + REGULATOR_MODE_NORMAL : REGULATOR_MODE_STANDBY; +} + static int max77802_get_opmode_shift(int id) { if (id == MAX77802_BUCK1 || (id >= MAX77802_BUCK5 && @@ -83,17 +94,16 @@ static int max77802_get_opmode_shift(int id) return -EINVAL; } -/* - * Some BUCKS supports Normal[ON/OFF] mode during suspend - * - * BUCK 1, 6, 2-4, 5, 7-10 (all) +/** + * max77802_set_suspend_disable - Disable the regulator during system suspend + * @rdev: regulator to mark as disabled * - * The other mode (0x02) will make PWRREQ switch between normal - * and low power. + * All regulators expect LDO 1, 3, 20 and 21 support OFF by PWRREQ. + * Configure the regulator so the PMIC will turn it OFF during system suspend. */ -static int max77802_buck_set_suspend_disable(struct regulator_dev *rdev) +static int max77802_set_suspend_disable(struct regulator_dev *rdev) { - unsigned int val = MAX77802_OPMODE_STANDBY; + unsigned int val = MAX77802_OFF_PWRREQ; struct max77802_regulator_prv *max77802 = rdev_get_drvdata(rdev); int id = rdev_get_id(rdev); int shift = max77802_get_opmode_shift(id); @@ -104,14 +114,11 @@ static int max77802_buck_set_suspend_disable(struct regulator_dev *rdev) } /* - * Some LDOs supports LPM-ON/OFF/Normal-ON mode during suspend state - * (Enable Control Logic1 by PWRREQ) - * - * LDOs 2, 4-19, 22-35. + * Some LDOs support Low Power Mode while the system is running. * + * LDOs 1, 3, 20, 21. */ -static int max77802_ldo_set_suspend_mode_logic1(struct regulator_dev *rdev, - unsigned int mode) +static int max77802_set_mode(struct regulator_dev *rdev, unsigned int mode) { struct max77802_regulator_prv *max77802 = rdev_get_drvdata(rdev); int id = rdev_get_id(rdev); @@ -119,14 +126,11 @@ static int max77802_ldo_set_suspend_mode_logic1(struct regulator_dev *rdev, int shift = max77802_get_opmode_shift(id); switch (mode) { - case REGULATOR_MODE_IDLE: /* ON in LP Mode */ - val = MAX77802_OPMODE_LP; - break; - case REGULATOR_MODE_NORMAL: /* ON in Normal Mode */ - val = MAX77802_OPMODE_NORMAL; + case REGULATOR_MODE_STANDBY: + val = MAX77802_OPMODE_LP; /* ON in Low Power Mode */ break; - case REGULATOR_MODE_STANDBY: /* ON/OFF by PWRREQ */ - val = MAX77802_OPMODE_STANDBY; + case REGULATOR_MODE_NORMAL: + val = MAX77802_OPMODE_NORMAL; /* ON in Normal Mode */ break; default: dev_warn(&rdev->dev, "%s: regulator mode: 0x%x not supported\n", @@ -139,35 +143,76 @@ static int max77802_ldo_set_suspend_mode_logic1(struct regulator_dev *rdev, rdev->desc->enable_mask, val << shift); } -/* - * Mode 1 (Output[ON/OFF] by PWRREQ) is not supported on some LDOs - * (Enable Control Logic2 by PWRREQ) +static unsigned max77802_get_mode(struct regulator_dev *rdev) +{ + struct max77802_regulator_prv *max77802 = rdev_get_drvdata(rdev); + int id = rdev_get_id(rdev); + + return max77802_map_mode(max77802->opmode[id]); +} + +/** + * max77802_set_suspend_mode - set regulator opmode when the system is suspended + * @rdev: regulator to change mode + * @mode: operating mode to be set + * + * Will set the operating mode for the regulators during system suspend. + * This function is valid for the three different enable control logics: * - * LDOs 1, 20, 21, and 3, + * Enable Control Logic1 by PWRREQ (BUCK 2-4 and LDOs 2, 4-19, 22-35) + * Enable Control Logic2 by PWRREQ (LDOs 1, 20, 21) + * Enable Control Logic3 by PWRREQ (LDO 3) * + * If setting the regulator mode fails, the function only warns but does + * not return an error code to avoid the regulator core to stop setting + * the operating mode for the remaining regulators. */ -static int max77802_ldo_set_suspend_mode_logic2(struct regulator_dev *rdev, - unsigned int mode) +static int max77802_set_suspend_mode(struct regulator_dev *rdev, + unsigned int mode) { struct max77802_regulator_prv *max77802 = rdev_get_drvdata(rdev); int id = rdev_get_id(rdev); unsigned int val; int shift = max77802_get_opmode_shift(id); + /* + * If the regulator has been disabled for suspend + * then is invalid to try setting a suspend mode. + */ + if (max77802->opmode[id] == MAX77802_OFF_PWRREQ) { + dev_warn(&rdev->dev, "%s: is disabled, mode: 0x%x not set\n", + rdev->desc->name, mode); + return 0; + } + switch (mode) { - case REGULATOR_MODE_IDLE: /* ON in LP Mode */ - val = MAX77802_OPMODE_LP; - break; - case REGULATOR_MODE_NORMAL: /* ON in Normal Mode */ - val = MAX77802_OPMODE_NORMAL; + case REGULATOR_MODE_STANDBY: + /* + * If the regulator opmode is normal then enable + * ON in Low Power Mode by PWRREQ. If the mode is + * already Low Power then no action is required. + */ + if (max77802->opmode[id] == MAX77802_OPMODE_NORMAL) + val = MAX77802_LP_PWRREQ; + else + return 0; break; + case REGULATOR_MODE_NORMAL: + /* + * If the regulator operating mode is Low Power then + * normal is not a valid opmode in suspend. If the + * mode is already normal then no action is required. + */ + if (max77802->opmode[id] == MAX77802_OPMODE_LP) + dev_warn(&rdev->dev, "%s: in Low Power: 0x%x invalid\n", + rdev->desc->name, mode); + return 0; default: dev_warn(&rdev->dev, "%s: regulator mode: 0x%x not supported\n", rdev->desc->name, mode); return -EINVAL; } - max77802->opmode[id] = val; return regmap_update_bits(rdev->regmap, rdev->desc->enable_reg, rdev->desc->enable_mask, val << shift); } @@ -178,6 +223,9 @@ static int max77802_enable(struct regulator_dev *rdev) int id = rdev_get_id(rdev); int shift = max77802_get_opmode_shift(id); + if (max77802->opmode[id] == MAX77802_OFF_PWRREQ) + max77802->opmode[id] = MAX77802_OPMODE_NORMAL; + return regmap_update_bits(rdev->regmap, rdev->desc->enable_reg, rdev->desc->enable_mask, max77802->opmode[id] << shift); @@ -247,7 +295,8 @@ static struct regulator_ops max77802_ldo_ops_logic1 = { .get_voltage_sel = regulator_get_voltage_sel_regmap, .set_voltage_sel = regulator_set_voltage_sel_regmap, .set_voltage_time_sel = regulator_set_voltage_time_sel, - .set_suspend_mode = max77802_ldo_set_suspend_mode_logic1, + .set_suspend_disable = max77802_set_suspend_disable, + .set_suspend_mode = max77802_set_suspend_mode, }; /* @@ -262,7 +311,9 @@ static struct regulator_ops max77802_ldo_ops_logic2 = { .get_voltage_sel = regulator_get_voltage_sel_regmap, .set_voltage_sel = regulator_set_voltage_sel_regmap, .set_voltage_time_sel = regulator_set_voltage_time_sel, - .set_suspend_mode = max77802_ldo_set_suspend_mode_logic2, + .set_mode = max77802_set_mode, + .get_mode = max77802_get_mode, + .set_suspend_mode = max77802_set_suspend_mode, }; /* BUCKS 1, 6 */ @@ -276,10 +327,25 @@ static struct regulator_ops max77802_buck_16_dvs_ops = { .set_voltage_sel = regulator_set_voltage_sel_regmap, .set_voltage_time_sel = regulator_set_voltage_time_sel, .set_ramp_delay = max77802_set_ramp_delay_4bit, - .set_suspend_disable = max77802_buck_set_suspend_disable, + .set_suspend_disable = max77802_set_suspend_disable, }; -/* BUCKs 2-4, 5, 7-10 */ +/* BUCKs 2-4 */ +static struct regulator_ops max77802_buck_234_ops = { + .list_voltage = regulator_list_voltage_linear, + .map_voltage = regulator_map_voltage_linear, + .is_enabled = regulator_is_enabled_regmap, + .enable = max77802_enable, + .disable = regulator_disable_regmap, + .get_voltage_sel = regulator_get_voltage_sel_regmap, + .set_voltage_sel = regulator_set_voltage_sel_regmap, + .set_voltage_time_sel = regulator_set_voltage_time_sel, + .set_ramp_delay = max77802_set_ramp_delay_2bit, + .set_suspend_disable = max77802_set_suspend_disable, + .set_suspend_mode = max77802_set_suspend_mode, +}; + +/* BUCKs 5, 7-10 */ static struct regulator_ops max77802_buck_dvs_ops = { .list_voltage = regulator_list_voltage_linear, .map_voltage = regulator_map_voltage_linear, @@ -290,7 +356,7 @@ static struct regulator_ops max77802_buck_dvs_ops = { .set_voltage_sel = regulator_set_voltage_sel_regmap, .set_voltage_time_sel = regulator_set_voltage_time_sel, .set_ramp_delay = max77802_set_ramp_delay_2bit, - .set_suspend_disable = max77802_buck_set_suspend_disable, + .set_suspend_disable = max77802_set_suspend_disable, }; /* LDOs 3-7, 9-14, 18-26, 28, 29, 32-34 */ @@ -352,7 +418,7 @@ static struct regulator_ops max77802_buck_dvs_ops = { .name = "BUCK"#num, \ .id = MAX77802_BUCK##num, \ .supply_name = "inb"#num, \ - .ops = &max77802_buck_dvs_ops, \ + .ops = &max77802_buck_234_ops, \ .type = REGULATOR_VOLTAGE, \ .owner = THIS_MODULE, \ .min_uV = 600000, \ @@ -402,7 +468,7 @@ static struct regulator_ops max77802_buck_dvs_ops = { .enable_mask = MAX77802_OPMODE_MASK, \ } -static struct regulator_desc regulators[] = { +static const struct regulator_desc regulators[] = { regulator_77802_desc_16_buck(1), regulator_77802_desc_234_buck(2), regulator_77802_desc_234_buck(3), @@ -540,14 +606,20 @@ static int max77802_pmic_probe(struct platform_device *pdev) config.of_node = pdata->regulators[i].of_node; ret = regmap_read(iodev->regmap, regulators[i].enable_reg, &val); - val = val >> shift & MAX77802_OPMODE_MASK; + if (ret < 0) { + dev_warn(&pdev->dev, + "cannot read current mode for %d\n", i); + val = MAX77802_OPMODE_NORMAL; + } else { + val = val >> shift & MAX77802_OPMODE_MASK; + } /* * If the regulator is disabled and the system warm rebooted, * the hardware reports OFF as the regulator operating mode. * Default to operating mode NORMAL in that case. */ - if (val == MAX77802_OPMODE_OFF) + if (val == MAX77802_STATUS_OFF) max77802->opmode[id] = MAX77802_OPMODE_NORMAL; else max77802->opmode[id] = val; |