summaryrefslogtreecommitdiff
path: root/drivers/spi/amba-pl022.c
diff options
context:
space:
mode:
Diffstat (limited to 'drivers/spi/amba-pl022.c')
-rw-r--r--drivers/spi/amba-pl022.c38
1 files changed, 28 insertions, 10 deletions
diff --git a/drivers/spi/amba-pl022.c b/drivers/spi/amba-pl022.c
index 5c2b092a915e..08de58e7f59f 100644
--- a/drivers/spi/amba-pl022.c
+++ b/drivers/spi/amba-pl022.c
@@ -324,6 +324,7 @@ struct vendor_data {
bool unidir;
bool extended_cr;
bool pl023;
+ bool loopback;
};
/**
@@ -660,7 +661,7 @@ static void readwriter(struct pl022 *pl022)
{
/*
- * The FIFO depth is different inbetween primecell variants.
+ * The FIFO depth is different between primecell variants.
* I believe filling in too much in the FIFO might cause
* errons in 8bit wide transfers on ARM variants (just 8 words
* FIFO, means only 8x8 = 64 bits in FIFO) at least.
@@ -721,7 +722,7 @@ static void readwriter(struct pl022 *pl022)
* This inner reader takes care of things appearing in the RX
* FIFO as we're transmitting. This will happen a lot since the
* clock starts running when you put things into the TX FIFO,
- * and then things are continously clocked into the RX FIFO.
+ * and then things are continuously clocked into the RX FIFO.
*/
while ((readw(SSP_SR(pl022->virtbase)) & SSP_SR_MASK_RNE)
&& (pl022->rx < pl022->rx_end)) {
@@ -841,7 +842,7 @@ static void dma_callback(void *data)
unmap_free_dma_scatter(pl022);
- /* Update total bytes transfered */
+ /* Update total bytes transferred */
msg->actual_length += pl022->cur_transfer->len;
if (pl022->cur_transfer->cs_change)
pl022->cur_chip->
@@ -1223,7 +1224,7 @@ static irqreturn_t pl022_interrupt_handler(int irq, void *dev_id)
"number of bytes on a 16bit bus?)\n",
(u32) (pl022->rx - pl022->rx_end));
}
- /* Update total bytes transfered */
+ /* Update total bytes transferred */
msg->actual_length += pl022->cur_transfer->len;
if (pl022->cur_transfer->cs_change)
pl022->cur_chip->
@@ -1414,11 +1415,11 @@ static void do_polling_transfer(struct pl022 *pl022)
SSP_CR1(pl022->virtbase));
dev_dbg(&pl022->adev->dev, "polling transfer ongoing ...\n");
- /* FIXME: insert a timeout so we don't hang here indefinately */
+ /* FIXME: insert a timeout so we don't hang here indefinitely */
while (pl022->tx < pl022->tx_end || pl022->rx < pl022->rx_end)
readwriter(pl022);
- /* Update total byte transfered */
+ /* Update total byte transferred */
message->actual_length += pl022->cur_transfer->len;
if (pl022->cur_transfer->cs_change)
pl022->cur_chip->cs_control(SSP_CHIP_DESELECT);
@@ -1554,7 +1555,7 @@ static int stop_queue(struct pl022 *pl022)
* A wait_queue on the pl022->busy could be used, but then the common
* execution path (pump_messages) would be required to call wake_up or
* friends on every SPI message. Do this instead */
- while (!list_empty(&pl022->queue) && pl022->busy && limit--) {
+ while ((!list_empty(&pl022->queue) || pl022->busy) && limit--) {
spin_unlock_irqrestore(&pl022->queue_lock, flags);
msleep(10);
spin_lock_irqsave(&pl022->queue_lock, flags);
@@ -1983,7 +1984,7 @@ static int pl022_setup(struct spi_device *spi)
SSP_WRITE_BITS(chip->cr0, clk_freq.scr, SSP_CR0_MASK_SCR, 8);
/* Loopback is available on all versions except PL023 */
- if (!pl022->vendor->pl023) {
+ if (pl022->vendor->loopback) {
if (spi->mode & SPI_LOOP)
tmp = LOOPBACK_ENABLED;
else
@@ -2128,7 +2129,7 @@ pl022_probe(struct amba_device *adev, const struct amba_id *id)
"probe - problem registering spi master\n");
goto err_spi_register;
}
- dev_dbg(dev, "probe succeded\n");
+ dev_dbg(dev, "probe succeeded\n");
/*
* Disable the silicon block pclk and any voltage domain and just
* power it up and clock it when it's needed
@@ -2183,7 +2184,7 @@ pl022_remove(struct amba_device *adev)
spi_unregister_master(pl022->master);
spi_master_put(pl022->master);
amba_set_drvdata(adev, NULL);
- dev_dbg(&adev->dev, "remove succeded\n");
+ dev_dbg(&adev->dev, "remove succeeded\n");
return 0;
}
@@ -2233,6 +2234,7 @@ static struct vendor_data vendor_arm = {
.unidir = false,
.extended_cr = false,
.pl023 = false,
+ .loopback = true,
};
@@ -2242,6 +2244,7 @@ static struct vendor_data vendor_st = {
.unidir = false,
.extended_cr = true,
.pl023 = false,
+ .loopback = true,
};
static struct vendor_data vendor_st_pl023 = {
@@ -2250,6 +2253,16 @@ static struct vendor_data vendor_st_pl023 = {
.unidir = false,
.extended_cr = true,
.pl023 = true,
+ .loopback = false,
+};
+
+static struct vendor_data vendor_db5500_pl023 = {
+ .fifodepth = 32,
+ .max_bpw = 32,
+ .unidir = false,
+ .extended_cr = true,
+ .pl023 = true,
+ .loopback = true,
};
static struct amba_id pl022_ids[] = {
@@ -2283,6 +2296,11 @@ static struct amba_id pl022_ids[] = {
.mask = 0xffffffff,
.data = &vendor_st_pl023,
},
+ {
+ .id = 0x10080023,
+ .mask = 0xffffffff,
+ .data = &vendor_db5500_pl023,
+ },
{ 0, 0 },
};