summaryrefslogtreecommitdiff
path: root/drivers/tty/serial/imx.c
diff options
context:
space:
mode:
Diffstat (limited to 'drivers/tty/serial/imx.c')
-rw-r--r--drivers/tty/serial/imx.c19
1 files changed, 18 insertions, 1 deletions
diff --git a/drivers/tty/serial/imx.c b/drivers/tty/serial/imx.c
index 91f3a1a5cb7f..c2fc6bef7a6f 100644
--- a/drivers/tty/serial/imx.c
+++ b/drivers/tty/serial/imx.c
@@ -316,7 +316,7 @@ static u32 imx_uart_readl(struct imx_port *sport, u32 offset)
* differ from the value that was last written. As it only
* clears after being set, reread conditionally.
*/
- if (sport->ucr2 & UCR2_SRST)
+ if (!(sport->ucr2 & UCR2_SRST))
sport->ucr2 = readl(sport->port.membase + offset);
return sport->ucr2;
break;
@@ -1833,6 +1833,11 @@ static int imx_uart_rs485_config(struct uart_port *port,
rs485conf->flags &= ~SER_RS485_ENABLED;
if (rs485conf->flags & SER_RS485_ENABLED) {
+ /* Enable receiver if low-active RTS signal is requested */
+ if (sport->have_rtscts && !sport->have_rtsgpio &&
+ !(rs485conf->flags & SER_RS485_RTS_ON_SEND))
+ rs485conf->flags |= SER_RS485_RX_DURING_TX;
+
/* disable transmitter */
ucr2 = imx_uart_readl(sport, UCR2);
if (rs485conf->flags & SER_RS485_RTS_AFTER_SEND)
@@ -2265,6 +2270,18 @@ static int imx_uart_probe(struct platform_device *pdev)
(!sport->have_rtscts && !sport->have_rtsgpio))
dev_err(&pdev->dev, "no RTS control, disabling rs485\n");
+ /*
+ * If using the i.MX UART RTS/CTS control then the RTS (CTS_B)
+ * signal cannot be set low during transmission in case the
+ * receiver is off (limitation of the i.MX UART IP).
+ */
+ if (sport->port.rs485.flags & SER_RS485_ENABLED &&
+ sport->have_rtscts && !sport->have_rtsgpio &&
+ (!(sport->port.rs485.flags & SER_RS485_RTS_ON_SEND) &&
+ !(sport->port.rs485.flags & SER_RS485_RX_DURING_TX)))
+ dev_err(&pdev->dev,
+ "low-active RTS not possible when receiver is off, enabling receiver\n");
+
imx_uart_rs485_config(&sport->port, &sport->port.rs485);
/* Disable interrupts before requesting them */