diff options
Diffstat (limited to 'drivers/tty/serial/imx.c')
-rw-r--r-- | drivers/tty/serial/imx.c | 63 |
1 files changed, 28 insertions, 35 deletions
diff --git a/drivers/tty/serial/imx.c b/drivers/tty/serial/imx.c index 708b9852a575..4aa72d5aeafb 100644 --- a/drivers/tty/serial/imx.c +++ b/drivers/tty/serial/imx.c @@ -415,13 +415,13 @@ static void imx_uart_stop_tx(struct uart_port *port) ucr1 = imx_uart_readl(sport, UCR1); imx_uart_writel(sport, ucr1 & ~UCR1_TRDYEN, UCR1); + ucr4 = imx_uart_readl(sport, UCR4); usr2 = imx_uart_readl(sport, USR2); - if (!(usr2 & USR2_TXDC)) { + if ((!(usr2 & USR2_TXDC)) && (ucr4 & UCR4_TCEN)) { /* The shifter is still busy, so retry once TC triggers */ return; } - ucr4 = imx_uart_readl(sport, UCR4); ucr4 &= ~UCR4_TCEN; imx_uart_writel(sport, ucr4, UCR4); @@ -1336,15 +1336,18 @@ static int imx_uart_dma_init(struct imx_port *sport) { struct dma_slave_config slave_config = {}; struct device *dev = sport->port.dev; + struct dma_chan *chan; int ret; /* Prepare for RX : */ - sport->dma_chan_rx = dma_request_slave_channel(dev, "rx"); - if (!sport->dma_chan_rx) { + chan = dma_request_chan(dev, "rx"); + if (IS_ERR(chan)) { dev_dbg(dev, "cannot get the DMA channel.\n"); - ret = -EINVAL; + sport->dma_chan_rx = NULL; + ret = PTR_ERR(chan); goto err; } + sport->dma_chan_rx = chan; slave_config.direction = DMA_DEV_TO_MEM; slave_config.src_addr = sport->port.mapbase + URXD0; @@ -1366,12 +1369,14 @@ static int imx_uart_dma_init(struct imx_port *sport) sport->rx_ring.buf = sport->rx_buf; /* Prepare for TX : */ - sport->dma_chan_tx = dma_request_slave_channel(dev, "tx"); - if (!sport->dma_chan_tx) { + chan = dma_request_chan(dev, "tx"); + if (IS_ERR(chan)) { dev_err(dev, "cannot get the TX DMA channel!\n"); - ret = -EINVAL; + sport->dma_chan_tx = NULL; + ret = PTR_ERR(chan); goto err; } + sport->dma_chan_tx = chan; slave_config.direction = DMA_MEM_TO_DEV; slave_config.dst_addr = sport->port.mapbase + URTX0; @@ -1943,10 +1948,6 @@ static int imx_uart_rs485_config(struct uart_port *port, struct ktermios *termio rs485conf->flags & SER_RS485_RX_DURING_TX) imx_uart_start_rx(port); - if (port->rs485_rx_during_tx_gpio) - gpiod_set_value_cansleep(port->rs485_rx_during_tx_gpio, - !!(rs485conf->flags & SER_RS485_RX_DURING_TX)); - return 0; } @@ -2210,7 +2211,6 @@ static enum hrtimer_restart imx_trigger_stop_tx(struct hrtimer *t) return HRTIMER_NORESTART; } -static const struct serial_rs485 imx_no_rs485 = {}; /* No RS485 if no RTS */ static const struct serial_rs485 imx_rs485_supported = { .flags = SER_RS485_ENABLED | SER_RS485_RTS_ON_SEND | SER_RS485_RTS_AFTER_SEND | SER_RS485_RX_DURING_TX, @@ -2294,8 +2294,6 @@ static int imx_uart_probe(struct platform_device *pdev) /* RTS is required to control the RS485 transmitter */ if (sport->have_rtscts || sport->have_rtsgpio) sport->port.rs485_supported = imx_rs485_supported; - else - sport->port.rs485_supported = imx_no_rs485; sport->port.flags = UPF_BOOT_AUTOCONF; timer_setup(&sport->timer, imx_uart_timeout, 0); @@ -2322,19 +2320,13 @@ static int imx_uart_probe(struct platform_device *pdev) /* For register access, we only need to enable the ipg clock. */ ret = clk_prepare_enable(sport->clk_ipg); if (ret) { - dev_err(&pdev->dev, "failed to enable per clk: %d\n", ret); + dev_err(&pdev->dev, "failed to enable ipg clk: %d\n", ret); return ret; } ret = uart_get_rs485_mode(&sport->port); - if (ret) { - clk_disable_unprepare(sport->clk_ipg); - return ret; - } - - if (sport->port.rs485.flags & SER_RS485_ENABLED && - (!sport->have_rtscts && !sport->have_rtsgpio)) - dev_err(&pdev->dev, "no RTS control, disabling rs485\n"); + if (ret) + goto err_clk; /* * If using the i.MX UART RTS/CTS control then the RTS (CTS_B) @@ -2414,8 +2406,6 @@ static int imx_uart_probe(struct platform_device *pdev) imx_uart_writel(sport, ucr3, UCR3); } - clk_disable_unprepare(sport->clk_ipg); - hrtimer_init(&sport->trigger_start_tx, CLOCK_MONOTONIC, HRTIMER_MODE_REL); hrtimer_init(&sport->trigger_stop_tx, CLOCK_MONOTONIC, HRTIMER_MODE_REL); sport->trigger_start_tx.function = imx_trigger_start_tx; @@ -2431,7 +2421,7 @@ static int imx_uart_probe(struct platform_device *pdev) if (ret) { dev_err(&pdev->dev, "failed to request rx irq: %d\n", ret); - return ret; + goto err_clk; } ret = devm_request_irq(&pdev->dev, txirq, imx_uart_txint, 0, @@ -2439,7 +2429,7 @@ static int imx_uart_probe(struct platform_device *pdev) if (ret) { dev_err(&pdev->dev, "failed to request tx irq: %d\n", ret); - return ret; + goto err_clk; } ret = devm_request_irq(&pdev->dev, rtsirq, imx_uart_rtsint, 0, @@ -2447,14 +2437,14 @@ static int imx_uart_probe(struct platform_device *pdev) if (ret) { dev_err(&pdev->dev, "failed to request rts irq: %d\n", ret); - return ret; + goto err_clk; } } else { ret = devm_request_irq(&pdev->dev, rxirq, imx_uart_int, 0, dev_name(&pdev->dev), sport); if (ret) { dev_err(&pdev->dev, "failed to request irq: %d\n", ret); - return ret; + goto err_clk; } } @@ -2462,16 +2452,19 @@ static int imx_uart_probe(struct platform_device *pdev) platform_set_drvdata(pdev, sport); - return uart_add_one_port(&imx_uart_uart_driver, &sport->port); + ret = uart_add_one_port(&imx_uart_uart_driver, &sport->port); + +err_clk: + clk_disable_unprepare(sport->clk_ipg); + + return ret; } -static int imx_uart_remove(struct platform_device *pdev) +static void imx_uart_remove(struct platform_device *pdev) { struct imx_port *sport = platform_get_drvdata(pdev); uart_remove_one_port(&imx_uart_uart_driver, &sport->port); - - return 0; } static void imx_uart_restore_context(struct imx_port *sport) @@ -2640,7 +2633,7 @@ static const struct dev_pm_ops imx_uart_pm_ops = { static struct platform_driver imx_uart_platform_driver = { .probe = imx_uart_probe, - .remove = imx_uart_remove, + .remove_new = imx_uart_remove, .driver = { .name = "imx-uart", |