| Age | Commit message (Collapse) | Author | Files | Lines |
|---|
|
On some systems a delay is needed after switching on the clocks, to allow
the output to stabilize and avoid a popping noise at the beginning of
the recording. Add the optional device tree property 'wakeup-delay-ms'
and apply the specified delay after enabling the mic. A blocking delay
can't be applied in dmic_daiops_trigger() since the function is called
in atomic context. Instead use a DAPM event handler to set the enable
GPIO and apply the delay in the handler.
Signed-off-by: Matthias Kaehlcke <mka@chromium.org>
Reviewed-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
The DMIC DAI driver specifies a number of 1 to 8 channels for each DAI.
The actual number of mics can currently not be configured in the device
tree or audio glue, but is derived from the min/max channels of the CPU
and codec DAI. A typical CPU DAI has two or more channels, in consequence
a single mic is treated as a stereo/multi channel device, even though
only one channel carries audio data.
This change adds the option to specify the number of used DMIC channels
in the device tree. When specified this value overwrites the default
channels_max value of 8 in the snd_soc_dai_driver struct of the codec.
Signed-off-by: Matthias Kaehlcke <mka@chromium.org>
Reviewed-by: Rob Herring <robh@kernel.org>
Acked-by: Arnaud Pouliquen <arnaud.pouliquen@st.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
there may use enable pin to control dmic start and stop,
so add this property in dt-bindings.
Signed-off-by: Lin Huang <hl@rock-chips.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
|
|
This patch adds documentation of device tree bindings for audio DMIC codec.
Signed-off-by: Arnaud Pouliquen <arnaud.pouliquen@st.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
|
