mx6: ddr: pass mx6_ddr_sysinfo to calibration routines

The DDR calibration routines have scattered support for bus
widths other than 64-bits:

-- The mmdc_do_write_level_calibration() routine assumes the
presence of PHY1, and
-- The mmdc_do_dqs_calibration() routine tries to determine
whether one or two DDR PHYs are active by reading MDCTL.

Since a caller of these routines must have a valid struct mx6_ddr_sysinfo
for use in calling mx6_dram_cfg(), and the bus width is available in the
"dsize" field, use this structure to inform the calibration routines which
PHYs are active.

This allows the use of the DDR calibration routines on CPU variants
like i.MX6SL that only have a single MMDC port.

Signed-off-by: Eric Nelson <eric@nelint.com>
Reviewed-by: Marek Vasut <marex@denx.de>

1 files changed, 2 insertions, 2 deletions

diff --git a/arch/arm/include/asm/arch-mx6/mx6-ddr.h b/arch/arm/include/asm/arch-mx6/mx6-ddr.h
index 53eb5fa9b0..cd5bc9768e 100644
--- a/arch/arm/include/asm/arch-mx6/mx6-ddr.h
+++ b/arch/arm/include/asm/arch-mx6/mx6-ddr.h
@@ -459,8 +459,8 @@ void mx6sl_dram_iocfg(unsigned width,
 		      const struct mx6sl_iomux_grp_regs *);
 
 #if defined(CONFIG_MX6QDL) || defined(CONFIG_MX6Q) || defined(CONFIG_MX6D)
-int mmdc_do_write_level_calibration(void);
-int mmdc_do_dqs_calibration(void);
+int mmdc_do_write_level_calibration(struct mx6_ddr_sysinfo const *sysinfo);
+int mmdc_do_dqs_calibration(struct mx6_ddr_sysinfo const *sysinfo);
 #endif
 
 /* configure mx6 mmdc registers */