diff options
Diffstat (limited to 'README')
| -rw-r--r-- | README | 29 |
1 files changed, 0 insertions, 29 deletions
@@ -565,11 +565,6 @@ The following options need to be configured: boards with QUICC Engines require OF_QE to set UCC MAC addresses - CONFIG_OF_BOARD_SETUP - - Board code has addition modification that it wants to make - to the flat device tree before handing it off to the kernel - CONFIG_OF_SYSTEM_SETUP Other code has addition modification that it wants to make @@ -596,9 +591,6 @@ The following options need to be configured: Note: If a "bootargs" environment is defined, it will override the defaults discussed just above. -- Cache Configuration: - CONFIG_SYS_L2CACHE_OFF- Do not enable L2 cache in U-Boot - - Cache Configuration for ARM: CONFIG_SYS_L2_PL310 - Enable support for ARM PL310 L2 cache controller @@ -1520,16 +1512,6 @@ The following options need to be configured: SPI EEPROM, also an instance works with Crystal A/D and D/As on the SACSng board) - CONFIG_SOFT_SPI - - Enables a software (bit-bang) SPI driver rather than - using hardware support. This is a general purpose - driver that only requires three general I/O port pins - (two outputs, one input) to function. If this is - defined, the board configuration must define several - SPI configuration items (port pins to use, etc). For - an example, see include/configs/sacsng.h. - CONFIG_SYS_SPI_MXC_WAIT Timeout for waiting until spi transfer completed. default: (CONFIG_SYS_HZ/100) /* 10 ms */ @@ -1595,13 +1577,6 @@ The following options need to be configured: Time to wait after FPGA configuration. The default is 200 ms. -- Configuration Management: - - CONFIG_IDENT_STRING - - If defined, this string will be added to the U-Boot - version information (U_BOOT_VERSION) - - Vendor Parameter Protection: U-Boot considers the values of the environment @@ -1922,10 +1897,6 @@ The following options need to be configured: CONFIG_SPL_INIT_MINIMAL Arch init code should be built for a very small image - CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION - Partition on the MMC to load U-Boot from when the MMC is being - used in raw mode - CONFIG_SYS_MMCSD_RAW_MODE_KERNEL_SECTOR Sector to load kernel uImage from when MMC is being used in raw mode (for Falcon mode) |