diff options
Diffstat (limited to 'board/eets/pdu001/Kconfig')
| -rw-r--r-- | board/eets/pdu001/Kconfig | 66 |
1 files changed, 66 insertions, 0 deletions
diff --git a/board/eets/pdu001/Kconfig b/board/eets/pdu001/Kconfig new file mode 100644 index 0000000000..6217a8f99b --- /dev/null +++ b/board/eets/pdu001/Kconfig @@ -0,0 +1,66 @@ +# Copyright (C) 2018 EETS GmbH - http://www.eets.ch/ +# +# SPDX-License-Identifier: GPL-2.0+ +# + +if TARGET_PDU001 + +config SYS_BOARD + default "pdu001" + +config SYS_VENDOR + default "eets" + +config SYS_SOC + default "am33xx" + +config SYS_CONFIG_NAME + default "pdu001" + +config CONS_INDEX + int "UART used for console" + range 1 6 + default 4 + help + The AM335x SoC has a total of 6 UARTs (UART0 to UART5 as referenced + in documentation, etc) available to it. The best choice for the + PDU001 is UART3 as it is wired to the header K2; enter 4 here to + use UART3. UART0 is connected to the EIA-485 transceiver. If you + really need to use it, you are advised to remove the transceiver U14 + from the board. UART1 is wired to the backplane and therefore + accessible from there or by the backplane connector K1 of the PDU. + Any other UART then UART3 (enter 4 here), UART1 (enter 2 here) or + UART0 (enter 1 here) are not sensible since they are not wired to + any connector and therefore difficult to access. + +choice + prompt "State of Run LED" + default PDU001_RUN_LED_RED + help + The PDU001 has a bi-color (red/green) LED labeled 'Run' which + can be used to indicate the operating state of the board. By + default it will be lit red by U-Boot. Later in the start-up + process it can be changed to green (or heartbeat or anything else) + by the kernel or some other software. + +config RUN_LED_RED + bool + prompt "Red" + help + Lit Run LED red. + +config RUN_LED_GREEN + bool + prompt "Green" + help + Lit Run LED green. + +config RUN_LED_OFF + bool + prompt "Off" + help + Do not lit Run LED. + +endchoice + +endif |