From e7b02781f5a962f7642aa929789235eec0c65b4d Mon Sep 17 00:00:00 2001 From: Simon Glass Date: Mon, 31 Jan 2022 07:49:34 -0700 Subject: sata: sata_sil: Only support BLK No boards use this driver without CONFIG_BLK, so clean up the dead code. Signed-off-by: Simon Glass Reviewed-by: Stefan Roese --- drivers/ata/sata_sil.c | 118 ++----------------------------------------------- 1 file changed, 3 insertions(+), 115 deletions(-) diff --git a/drivers/ata/sata_sil.c b/drivers/ata/sata_sil.c index dda712f42c..a4f0dae4bb 100644 --- a/drivers/ata/sata_sil.c +++ b/drivers/ata/sata_sil.c @@ -6,7 +6,9 @@ */ #include +#include #include +#include #include #include #include @@ -17,13 +19,8 @@ #include #include #include -#include - -#if CONFIG_IS_ENABLED(BLK) -#include -#include #include -#endif +#include #include "sata_sil.h" @@ -480,18 +477,12 @@ static void sil_sata_cmd_flush_cache_ext(struct sil_sata *sata) /* * SATA interface between low level driver and command layer */ -#if !CONFIG_IS_ENABLED(BLK) -ulong sata_read(int dev, ulong blknr, lbaint_t blkcnt, void *buffer) -{ - struct sil_sata *sata = (struct sil_sata *)sata_dev_desc[dev].priv; -#else static ulong sata_read(struct udevice *dev, lbaint_t blknr, lbaint_t blkcnt, void *buffer) { struct sil_sata_priv *priv = dev_get_plat(dev); int port_number = priv->port_num; struct sil_sata *sata = priv->sil_sata_desc[port_number]; -#endif ulong rc; if (sata->lba48) @@ -505,18 +496,12 @@ static ulong sata_read(struct udevice *dev, lbaint_t blknr, lbaint_t blkcnt, /* * SATA interface between low level driver and command layer */ -#if !CONFIG_IS_ENABLED(BLK) -ulong sata_write(int dev, ulong blknr, lbaint_t blkcnt, const void *buffer) -{ - struct sil_sata *sata = (struct sil_sata *)sata_dev_desc[dev].priv; -#else ulong sata_write(struct udevice *dev, lbaint_t blknr, lbaint_t blkcnt, const void *buffer) { struct sil_sata_priv *priv = dev_get_plat(dev); int port_number = priv->port_num; struct sil_sata *sata = priv->sil_sata_desc[port_number]; -#endif ulong rc; if (sata->lba48) { @@ -532,14 +517,9 @@ ulong sata_write(struct udevice *dev, lbaint_t blknr, lbaint_t blkcnt, return rc; } -#if !CONFIG_IS_ENABLED(BLK) -static int sil_init_sata(int dev) -{ -#else static int sil_init_sata(struct udevice *uc_dev, int dev) { struct sil_sata_priv *priv = dev_get_plat(uc_dev); -#endif struct sil_sata *sata; void *port; u32 tmp; @@ -606,14 +586,9 @@ static int sil_init_sata(struct udevice *uc_dev, int dev) memset((void *)sata, 0, sizeof(struct sil_sata)); /* Save the private struct to block device struct */ -#if !CONFIG_IS_ENABLED(BLK) - sata_dev_desc[dev].priv = (void *)sata; - sata->devno = sata_info.devno; -#else priv->sil_sata_desc[dev] = sata; priv->port_num = dev; sata->devno = uc_dev->parent; -#endif sata->id = dev; sata->port = port; sprintf(sata->name, "SATA#%d", dev); @@ -625,85 +600,11 @@ static int sil_init_sata(struct udevice *uc_dev, int dev) return 0; } -#if !CONFIG_IS_ENABLED(BLK) -/* - * SATA interface between low level driver and command layer - */ -int init_sata(int dev) -{ - static int init_done, idx; - pci_dev_t devno; - u16 word; - - if (init_done == 1 && dev < sata_info.maxport) - goto init_start; - - init_done = 1; - - /* Find PCI device(s) */ - devno = pci_find_devices(supported, idx++); - if (devno == -1) - return 1; - - pci_read_config_word(devno, PCI_DEVICE_ID, &word); - - /* get the port count */ - word &= 0xf; - - sata_info.portbase = 0; - sata_info.maxport = sata_info.portbase + word; - sata_info.devno = devno; - - /* Read out all BARs */ - sata_info.iobase[0] = (ulong)pci_map_bar(devno, - PCI_BASE_ADDRESS_0, PCI_REGION_MEM); - sata_info.iobase[1] = (ulong)pci_map_bar(devno, - PCI_BASE_ADDRESS_2, PCI_REGION_MEM); - - /* mask out the unused bits */ - sata_info.iobase[0] &= 0xffffff80; - sata_info.iobase[1] &= 0xfffffc00; - - /* Enable Bus Mastering and memory region */ - pci_write_config_word(devno, PCI_COMMAND, - PCI_COMMAND_MEMORY | PCI_COMMAND_MASTER); - - /* Check if mem accesses and Bus Mastering are enabled. */ - pci_read_config_word(devno, PCI_COMMAND, &word); - if (!(word & PCI_COMMAND_MEMORY) || - (!(word & PCI_COMMAND_MASTER))) { - printf("Error: Can not enable MEM access or Bus Mastering.\n"); - debug("PCI command: %04x\n", word); - return 1; - } - - /* GPIO off */ - writel(0, (void *)(sata_info.iobase[0] + HOST_FLASH_CMD)); - /* clear global reset & mask interrupts during initialization */ - writel(0, (void *)(sata_info.iobase[0] + HOST_CTRL)); - -init_start: - return sil_init_sata(dev); -} - -int reset_sata(int dev) -{ - return 0; -} - -/* - * SATA interface between low level driver and command layer - */ -int scan_sata(int dev) -{ - struct sil_sata *sata = (struct sil_sata *)sata_dev_desc[dev].priv; -#else static int scan_sata(struct udevice *blk_dev, int dev) { struct blk_desc *desc = dev_get_uclass_plat(blk_dev); struct sil_sata_priv *priv = dev_get_plat(blk_dev); struct sil_sata *sata = priv->sil_sata_desc[dev]; -#endif unsigned char serial[ATA_ID_SERNO_LEN + 1]; unsigned char firmware[ATA_ID_FW_REV_LEN + 1]; unsigned char product[ATA_ID_PROD_LEN + 1]; @@ -727,16 +628,6 @@ static int scan_sata(struct udevice *blk_dev, int dev) /* Product model */ ata_id_c_string(id, product, ATA_ID_PROD, sizeof(product)); -#if !CONFIG_IS_ENABLED(BLK) - memcpy(sata_dev_desc[dev].product, serial, sizeof(serial)); - memcpy(sata_dev_desc[dev].revision, firmware, sizeof(firmware)); - memcpy(sata_dev_desc[dev].vendor, product, sizeof(product)); - /* Totoal sectors */ - sata_dev_desc[dev].lba = ata_id_n_sectors(id); -#ifdef CONFIG_LBA48 - sata_dev_desc[dev].lba48 = sata->lba48; -#endif -#else memcpy(desc->product, serial, sizeof(serial)); memcpy(desc->revision, firmware, sizeof(firmware)); memcpy(desc->vendor, product, sizeof(product)); @@ -744,7 +635,6 @@ static int scan_sata(struct udevice *blk_dev, int dev) #ifdef CONFIG_LBA48 desc->lba48 = sata->lba48; #endif -#endif #ifdef DEBUG ata_dump_id(id); @@ -754,7 +644,6 @@ static int scan_sata(struct udevice *blk_dev, int dev) return 0; } -#if CONFIG_IS_ENABLED(BLK) static const struct blk_ops sata_sil_blk_ops = { .read = sata_read, .write = sata_write, @@ -916,4 +805,3 @@ U_BOOT_DRIVER(sil_ahci_pci) = { }; U_BOOT_PCI_DEVICE(sil_ahci_pci, supported); -#endif -- cgit v1.2.3