From 6f6b7cfa89e5aa3b643196a4ccc8b1ba5d6fa7a4 Mon Sep 17 00:00:00 2001 From: Tom Rini Date: Tue, 6 Mar 2018 19:02:27 -0500 Subject: Convert all of CONFIG_CONS_INDEX to Kconfig This converts the following to Kconfig: CONFIG_CONS_INDEX We have existing entries for this option in a number of places, with different guards on them. They're also sometimes used for things not directly inside of the serial driver. First, introduce a new symbol to guard the use of CONFIG_CONS_INDEX, so that in the case where we don't need this for the serial driver, but for some other use, we can still do it. Next, consolidate all of these into the single entry in drivers/serial/Kconfig. Finally, introduce CONS_INDEX_[023456] so that we can imply a correct value here to make the defconfig side of this smaller. Signed-off-by: Adam Ford [trini: Rework a lot of the logic here, such that I took authorship from Adam, but kept his S-o-B line] Signed-off-by: Tom Rini --- board/eets/pdu001/Kconfig | 16 ---------------- 1 file changed, 16 deletions(-) (limited to 'board/eets') diff --git a/board/eets/pdu001/Kconfig b/board/eets/pdu001/Kconfig index 6217a8f99b..f28ba6e7bf 100644 --- a/board/eets/pdu001/Kconfig +++ b/board/eets/pdu001/Kconfig @@ -17,22 +17,6 @@ config SYS_SOC config SYS_CONFIG_NAME default "pdu001" -config CONS_INDEX - int "UART used for console" - range 1 6 - default 4 - help - The AM335x SoC has a total of 6 UARTs (UART0 to UART5 as referenced - in documentation, etc) available to it. The best choice for the - PDU001 is UART3 as it is wired to the header K2; enter 4 here to - use UART3. UART0 is connected to the EIA-485 transceiver. If you - really need to use it, you are advised to remove the transceiver U14 - from the board. UART1 is wired to the backplane and therefore - accessible from there or by the backplane connector K1 of the PDU. - Any other UART then UART3 (enter 4 here), UART1 (enter 2 here) or - UART0 (enter 1 here) are not sensible since they are not wired to - any connector and therefore difficult to access. - choice prompt "State of Run LED" default PDU001_RUN_LED_RED -- cgit v1.2.3