From 27084c03d36a7f0e4d7c1679761e81567f1d5442 Mon Sep 17 00:00:00 2001 From: Simon Glass Date: Wed, 25 Sep 2019 08:56:27 -0600 Subject: spl: Allow tiny printf() to be controlled in SPL and TPL At present there is only one control for this and it is used for both SPL and TPL. But SPL might have a lot more space than TPL so the extra cost of a full printf() might be acceptable. Split the option into two, providing separate SPL and TPL controls. The TPL setting defaults to the same as SPL. Signed-off-by: Simon Glass Reviewed-by: Bin Meng --- common/spl/Kconfig | 2 +- common/xyzModem.c | 2 +- 2 files changed, 2 insertions(+), 2 deletions(-) (limited to 'common') diff --git a/common/spl/Kconfig b/common/spl/Kconfig index 62b93c112b..048b85ba7a 100644 --- a/common/spl/Kconfig +++ b/common/spl/Kconfig @@ -963,7 +963,7 @@ config SPL_SERIAL_SUPPORT for displaying messages while SPL is running. It also brings in printf() and panic() functions. This should normally be enabled unless there are space reasons not to. Even then, consider - enabling USE_TINY_PRINTF which is a small printf() version. + enabling SPL_USE_TINY_PRINTF which is a small printf() version. config SPL_SPI_FLASH_SUPPORT bool "Support SPI flash drivers" diff --git a/common/xyzModem.c b/common/xyzModem.c index e85da74a69..6bf2375671 100644 --- a/common/xyzModem.c +++ b/common/xyzModem.c @@ -173,7 +173,7 @@ parse_num (char *s, unsigned long *val, char **es, char *delim) } -#if defined(DEBUG) && !defined(CONFIG_USE_TINY_PRINTF) +#if defined(DEBUG) && !CONFIG_IS_ENABLED(USE_TINY_PRINTF) /* * Note: this debug setup works by storing the strings in a fixed buffer */ -- cgit v1.2.3