From 570c3dcfc153e0f18bd897630236da6605dcbe7e Mon Sep 17 00:00:00 2001 From: Tom Rini Date: Sat, 22 May 2021 08:47:14 -0400 Subject: arm: Remove spear600 boards and the rest of SPEAr support These boards have not been converted to CONFIG_DM_USB by the deadline and is also missing conversion to CONFIG_DM. Remove them. As this is the last of the SPEAr platforms, so remove the rest of the remaining support as well. Cc: Vipin Kumar Signed-off-by: Tom Rini --- drivers/mtd/nand/raw/fsmc_nand.c | 49 ---------------------------------------- 1 file changed, 49 deletions(-) (limited to 'drivers/mtd') diff --git a/drivers/mtd/nand/raw/fsmc_nand.c b/drivers/mtd/nand/raw/fsmc_nand.c index 1f4c74f0f6..1c24710b2d 100644 --- a/drivers/mtd/nand/raw/fsmc_nand.c +++ b/drivers/mtd/nand/raw/fsmc_nand.c @@ -389,55 +389,6 @@ static int fsmc_read_page_hwecc(struct mtd_info *mtd, struct nand_chip *chip, return 0; } -#ifndef CONFIG_SPL_BUILD -/* - * fsmc_nand_switch_ecc - switch the ECC operation between different engines - * - * @eccstrength - the number of bits that could be corrected - * (1 - HW, 4 - SW BCH4) - */ -int fsmc_nand_switch_ecc(uint32_t eccstrength) -{ - struct nand_chip *nand; - struct mtd_info *mtd; - int err; - - /* - * This functions is only called on SPEAr600 platforms, supporting - * 1 bit HW ECC. The BCH8 HW ECC (FSMC_VER8) from the ST-Ericsson - * Nomadik SoC is currently supporting this fsmc_nand_switch_ecc() - * function, as it doesn't need to switch to a different ECC layout. - */ - mtd = get_nand_dev_by_index(nand_curr_device); - nand = mtd_to_nand(mtd); - - /* Setup the ecc configurations again */ - if (eccstrength == 1) { - nand->ecc.mode = NAND_ECC_HW; - nand->ecc.bytes = 3; - nand->ecc.strength = 1; - nand->ecc.layout = &fsmc_ecc1_layout; - nand->ecc.calculate = fsmc_read_hwecc; - nand->ecc.correct = nand_correct_data; - } else if (eccstrength == 4) { - /* - * .calculate .correct and .bytes will be set in - * nand_scan_tail() - */ - nand->ecc.mode = NAND_ECC_SOFT_BCH; - nand->ecc.strength = 4; - nand->ecc.layout = NULL; - } else { - printf("Error: ECC strength %d not supported!\n", eccstrength); - } - - /* Update NAND handling after ECC mode switch */ - err = nand_scan_tail(mtd); - - return err; -} -#endif /* CONFIG_SPL_BUILD */ - int fsmc_nand_init(struct nand_chip *nand) { static int chip_nr; -- cgit v1.2.3