1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
271
272
273
274
275
276
277
278
279
280
281
282
283
284
285
286
287
288
289
290
291
292
293
294
|
// SPDX-License-Identifier: GPL-2.0
/*
* AM625: SoC specific initialization
*
* Copyright (C) 2020-2022 Texas Instruments Incorporated - https://www.ti.com/
* Suman Anna <s-anna@ti.com>
*/
#include <spl.h>
#include <asm/io.h>
#include <asm/arch/hardware.h>
#include <asm/arch/sysfw-loader.h>
#include "common.h"
#include <dm.h>
#include <dm/uclass-internal.h>
#include <dm/pinctrl.h>
#if defined(CONFIG_SPL_BUILD)
/*
* This uninitialized global variable would normal end up in the .bss section,
* but the .bss is cleared between writing and reading this variable, so move
* it to the .data section.
*/
u32 bootindex __section(".data");
static struct rom_extended_boot_data bootdata __section(".data");
static void store_boot_info_from_rom(void)
{
bootindex = *(u32 *)(CONFIG_SYS_K3_BOOT_PARAM_TABLE_INDEX);
memcpy(&bootdata, (uintptr_t *)ROM_ENTENDED_BOOT_DATA_INFO,
sizeof(struct rom_extended_boot_data));
}
static void ctrl_mmr_unlock(void)
{
/* Unlock all WKUP_CTRL_MMR0 module registers */
mmr_unlock(WKUP_CTRL_MMR0_BASE, 0);
mmr_unlock(WKUP_CTRL_MMR0_BASE, 1);
mmr_unlock(WKUP_CTRL_MMR0_BASE, 2);
mmr_unlock(WKUP_CTRL_MMR0_BASE, 3);
mmr_unlock(WKUP_CTRL_MMR0_BASE, 4);
mmr_unlock(WKUP_CTRL_MMR0_BASE, 5);
mmr_unlock(WKUP_CTRL_MMR0_BASE, 6);
mmr_unlock(WKUP_CTRL_MMR0_BASE, 7);
/* Unlock all CTRL_MMR0 module registers */
mmr_unlock(CTRL_MMR0_BASE, 0);
mmr_unlock(CTRL_MMR0_BASE, 1);
mmr_unlock(CTRL_MMR0_BASE, 2);
mmr_unlock(CTRL_MMR0_BASE, 4);
mmr_unlock(CTRL_MMR0_BASE, 6);
/* Unlock all MCU_CTRL_MMR0 module registers */
mmr_unlock(MCU_CTRL_MMR0_BASE, 0);
mmr_unlock(MCU_CTRL_MMR0_BASE, 1);
mmr_unlock(MCU_CTRL_MMR0_BASE, 2);
mmr_unlock(MCU_CTRL_MMR0_BASE, 3);
mmr_unlock(MCU_CTRL_MMR0_BASE, 4);
mmr_unlock(MCU_CTRL_MMR0_BASE, 6);
/* Unlock PADCFG_CTRL_MMR padconf registers */
mmr_unlock(PADCFG_MMR0_BASE, 1);
mmr_unlock(PADCFG_MMR1_BASE, 1);
}
static __maybe_unused void enable_mcu_esm_reset(void)
{
/* Set CTRLMMR_MCU_RST_CTRL:MCU_ESM_ERROR_RST_EN_Z to '0' (low active) */
u32 stat = readl(CTRLMMR_MCU_RST_CTRL);
stat &= RST_CTRL_ESM_ERROR_RST_EN_Z_MASK;
writel(stat, CTRLMMR_MCU_RST_CTRL);
}
void board_init_f(ulong dummy)
{
struct udevice *dev;
int ret;
#if defined(CONFIG_CPU_V7R)
setup_k3_mpu_regions();
#endif
/*
* Cannot delay this further as there is a chance that
* K3_BOOT_PARAM_TABLE_INDEX can be over written by SPL MALLOC section.
*/
store_boot_info_from_rom();
ctrl_mmr_unlock();
/* Init DM early */
spl_early_init();
/*
* Process pinctrl for the serial0 and serial3, aka WKUP_UART0 and
* MAIN_UART1 modules and continue regardless of the result of pinctrl.
* Do this without probing the device, but instead by searching the
* device that would request the given sequence number if probed. The
* UARTs will be used by the DM firmware and TIFS firmware images
* respectively and the firmware depend on SPL to initialize the pin
* settings.
*/
ret = uclass_find_device_by_seq(UCLASS_SERIAL, 0, &dev);
if (!ret)
pinctrl_select_state(dev, "default");
ret = uclass_find_device_by_seq(UCLASS_SERIAL, 3, &dev);
if (!ret)
pinctrl_select_state(dev, "default");
preloader_console_init();
#ifdef CONFIG_K3_EARLY_CONS
/*
* Allow establishing an early console as required for example when
* doing a UART-based boot. Note that this console may not "survive"
* through a SYSFW PM-init step and will need a re-init in some way
* due to changing module clock frequencies.
*/
early_console_init();
#endif
#if defined(CONFIG_K3_LOAD_SYSFW)
/*
* Configure and start up system controller firmware. Provide
* the U-Boot console init function to the SYSFW post-PM configuration
* callback hook, effectively switching on (or over) the console
* output.
*/
ret = is_rom_loaded_sysfw(&bootdata);
if (!ret)
panic("ROM has not loaded TIFS firmware\n");
k3_sysfw_loader(true, NULL, NULL);
#endif
/*
* Force probe of clk_k3 driver here to ensure basic default clock
* configuration is always done.
*/
if (IS_ENABLED(CONFIG_SPL_CLK_K3)) {
ret = uclass_get_device_by_driver(UCLASS_CLK,
DM_DRIVER_GET(ti_clk),
&dev);
if (ret)
printf("Failed to initialize clk-k3!\n");
}
/* Output System Firmware version info */
k3_sysfw_print_ver();
if (IS_ENABLED(CONFIG_ESM_K3)) {
/* Probe/configure ESM0 */
ret = uclass_get_device_by_name(UCLASS_MISC, "esm@420000", &dev);
if (ret)
printf("esm main init failed: %d\n", ret);
/* Probe/configure MCUESM */
ret = uclass_get_device_by_name(UCLASS_MISC, "esm@4100000", &dev);
if (ret)
printf("esm mcu init failed: %d\n", ret);
enable_mcu_esm_reset();
}
#if defined(CONFIG_K3_AM64_DDRSS)
ret = uclass_get_device(UCLASS_RAM, 0, &dev);
if (ret)
panic("DRAM init failed: %d\n", ret);
#endif
}
u32 spl_mmc_boot_mode(struct mmc *mmc, const u32 boot_device)
{
u32 devstat = readl(CTRLMMR_MAIN_DEVSTAT);
u32 bootmode_cfg = (devstat & MAIN_DEVSTAT_PRIMARY_BOOTMODE_CFG_MASK) >>
MAIN_DEVSTAT_PRIMARY_BOOTMODE_CFG_SHIFT;
switch (boot_device) {
case BOOT_DEVICE_MMC1:
if ((bootmode_cfg & MAIN_DEVSTAT_PRIMARY_MMC_FS_RAW_MASK) >>
MAIN_DEVSTAT_PRIMARY_MMC_FS_RAW_SHIFT)
return MMCSD_MODE_EMMCBOOT;
return MMCSD_MODE_FS;
case BOOT_DEVICE_MMC2:
return MMCSD_MODE_FS;
default:
return MMCSD_MODE_RAW;
}
}
static u32 __get_backup_bootmedia(u32 devstat)
{
u32 bkup_bootmode = (devstat & MAIN_DEVSTAT_BACKUP_BOOTMODE_MASK) >>
MAIN_DEVSTAT_BACKUP_BOOTMODE_SHIFT;
u32 bkup_bootmode_cfg =
(devstat & MAIN_DEVSTAT_BACKUP_BOOTMODE_CFG_MASK) >>
MAIN_DEVSTAT_BACKUP_BOOTMODE_CFG_SHIFT;
switch (bkup_bootmode) {
case BACKUP_BOOT_DEVICE_UART:
return BOOT_DEVICE_UART;
case BACKUP_BOOT_DEVICE_USB:
return BOOT_DEVICE_USB;
case BACKUP_BOOT_DEVICE_ETHERNET:
return BOOT_DEVICE_ETHERNET;
case BACKUP_BOOT_DEVICE_MMC:
if (bkup_bootmode_cfg)
return BOOT_DEVICE_MMC2;
return BOOT_DEVICE_MMC1;
case BACKUP_BOOT_DEVICE_SPI:
return BOOT_DEVICE_SPI;
case BACKUP_BOOT_DEVICE_I2C:
return BOOT_DEVICE_I2C;
case BACKUP_BOOT_DEVICE_DFU:
if (bkup_bootmode_cfg & MAIN_DEVSTAT_BACKUP_USB_MODE_MASK)
return BOOT_DEVICE_USB;
return BOOT_DEVICE_DFU;
};
return BOOT_DEVICE_RAM;
}
static u32 __get_primary_bootmedia(u32 devstat)
{
u32 bootmode = (devstat & MAIN_DEVSTAT_PRIMARY_BOOTMODE_MASK) >>
MAIN_DEVSTAT_PRIMARY_BOOTMODE_SHIFT;
u32 bootmode_cfg = (devstat & MAIN_DEVSTAT_PRIMARY_BOOTMODE_CFG_MASK) >>
MAIN_DEVSTAT_PRIMARY_BOOTMODE_CFG_SHIFT;
switch (bootmode) {
case BOOT_DEVICE_OSPI:
fallthrough;
case BOOT_DEVICE_QSPI:
fallthrough;
case BOOT_DEVICE_XSPI:
fallthrough;
case BOOT_DEVICE_SPI:
return BOOT_DEVICE_SPI;
case BOOT_DEVICE_ETHERNET_RGMII:
fallthrough;
case BOOT_DEVICE_ETHERNET_RMII:
return BOOT_DEVICE_ETHERNET;
case BOOT_DEVICE_EMMC:
return BOOT_DEVICE_MMC1;
case BOOT_DEVICE_MMC:
if ((bootmode_cfg & MAIN_DEVSTAT_PRIMARY_MMC_PORT_MASK) >>
MAIN_DEVSTAT_PRIMARY_MMC_PORT_SHIFT)
return BOOT_DEVICE_MMC2;
return BOOT_DEVICE_MMC1;
case BOOT_DEVICE_DFU:
if ((bootmode_cfg & MAIN_DEVSTAT_PRIMARY_USB_MODE_MASK) >>
MAIN_DEVSTAT_PRIMARY_USB_MODE_SHIFT)
return BOOT_DEVICE_USB;
return BOOT_DEVICE_DFU;
case BOOT_DEVICE_NOBOOT:
return BOOT_DEVICE_RAM;
}
return bootmode;
}
u32 spl_boot_device(void)
{
u32 devstat = readl(CTRLMMR_MAIN_DEVSTAT);
u32 bootmedia;
if (bootindex == K3_PRIMARY_BOOTMODE)
bootmedia = __get_primary_bootmedia(devstat);
else
bootmedia = __get_backup_bootmedia(devstat);
debug("am625_init: %s: devstat = 0x%x bootmedia = 0x%x bootindex = %d\n",
__func__, devstat, bootmedia, bootindex);
return bootmedia;
}
#endif /* CONFIG_SPL_BUILD */
|