diff options
Diffstat (limited to 'Documentation/devicetree/bindings/net/nfc')
-rw-r--r-- | Documentation/devicetree/bindings/net/nfc/nxp-nci.txt | 2 | ||||
-rw-r--r-- | Documentation/devicetree/bindings/net/nfc/samsung,s3fwrn5.yaml | 33 |
2 files changed, 30 insertions, 5 deletions
diff --git a/Documentation/devicetree/bindings/net/nfc/nxp-nci.txt b/Documentation/devicetree/bindings/net/nfc/nxp-nci.txt index 9e4dc510a40a..285a37c2f189 100644 --- a/Documentation/devicetree/bindings/net/nfc/nxp-nci.txt +++ b/Documentation/devicetree/bindings/net/nfc/nxp-nci.txt @@ -6,11 +6,11 @@ Required properties: - reg: address on the bus - interrupts: GPIO interrupt to which the chip is connected - enable-gpios: Output GPIO pin used for enabling/disabling the chip -- firmware-gpios: Output GPIO pin used to enter firmware download mode Optional SoC Specific Properties: - pinctrl-names: Contains only one value - "default". - pintctrl-0: Specifies the pin control groups used for this controller. +- firmware-gpios: Output GPIO pin used to enter firmware download mode Example (for ARM-based BeagleBone with NPC100 NFC controller on I2C2): diff --git a/Documentation/devicetree/bindings/net/nfc/samsung,s3fwrn5.yaml b/Documentation/devicetree/bindings/net/nfc/samsung,s3fwrn5.yaml index cb0b8a560282..477066e2b821 100644 --- a/Documentation/devicetree/bindings/net/nfc/samsung,s3fwrn5.yaml +++ b/Documentation/devicetree/bindings/net/nfc/samsung,s3fwrn5.yaml @@ -12,7 +12,9 @@ maintainers: properties: compatible: - const: samsung,s3fwrn5-i2c + enum: + - samsung,s3fwrn5-i2c + - samsung,s3fwrn82 en-gpios: maxItems: 1 @@ -47,10 +49,19 @@ additionalProperties: false required: - compatible - en-gpios - - interrupts - - reg - wake-gpios +allOf: + - if: + properties: + compatible: + contains: + const: samsung,s3fwrn5-i2c + then: + required: + - interrupts + - reg + examples: - | #include <dt-bindings/gpio/gpio.h> @@ -65,9 +76,23 @@ examples: reg = <0x27>; interrupt-parent = <&gpa1>; - interrupts = <3 IRQ_TYPE_LEVEL_HIGH>; + interrupts = <3 IRQ_TYPE_EDGE_RISING>; en-gpios = <&gpf1 4 GPIO_ACTIVE_HIGH>; wake-gpios = <&gpj0 2 GPIO_ACTIVE_HIGH>; }; }; + # UART example on Raspberry Pi + - | + uart0 { + status = "okay"; + + nfc { + compatible = "samsung,s3fwrn82"; + + en-gpios = <&gpio 20 GPIO_ACTIVE_HIGH>; + wake-gpios = <&gpio 16 GPIO_ACTIVE_HIGH>; + + status = "okay"; + }; + }; |