diff options
Diffstat (limited to 'drivers/net/phy/at803x.c')
| -rw-r--r-- | drivers/net/phy/at803x.c | 40 |
1 files changed, 16 insertions, 24 deletions
diff --git a/drivers/net/phy/at803x.c b/drivers/net/phy/at803x.c index bdac087058b2..5ae39d236b30 100644 --- a/drivers/net/phy/at803x.c +++ b/drivers/net/phy/at803x.c @@ -666,25 +666,7 @@ static int at803x_probe(struct phy_device *phydev) return ret; } - /* Some bootloaders leave the fiber page selected. - * Switch to the copper page, as otherwise we read - * the PHY capabilities from the fiber side. - */ - if (phydev->drv->phy_id == ATH8031_PHY_ID) { - phy_lock_mdio_bus(phydev); - ret = at803x_write_page(phydev, AT803X_PAGE_COPPER); - phy_unlock_mdio_bus(phydev); - if (ret) - goto err; - } - return 0; - -err: - if (priv->vddio) - regulator_disable(priv->vddio); - - return ret; } static void at803x_remove(struct phy_device *phydev) @@ -785,6 +767,22 @@ static int at803x_config_init(struct phy_device *phydev) { int ret; + if (phydev->drv->phy_id == ATH8031_PHY_ID) { + /* Some bootloaders leave the fiber page selected. + * Switch to the copper page, as otherwise we read + * the PHY capabilities from the fiber side. + */ + phy_lock_mdio_bus(phydev); + ret = at803x_write_page(phydev, AT803X_PAGE_COPPER); + phy_unlock_mdio_bus(phydev); + if (ret) + return ret; + + ret = at8031_pll_config(phydev); + if (ret < 0) + return ret; + } + /* The RX and TX delay default is: * after HW reset: RX delay enabled and TX delay disabled * after SW reset: RX delay enabled, while TX delay retains the @@ -814,12 +812,6 @@ static int at803x_config_init(struct phy_device *phydev) if (ret < 0) return ret; - if (phydev->drv->phy_id == ATH8031_PHY_ID) { - ret = at8031_pll_config(phydev); - if (ret < 0) - return ret; - } - /* Ar803x extended next page bit is enabled by default. Cisco * multigig switches read this bit and attempt to negotiate 10Gbps * rates even if the next page bit is disabled. This is incorrect |