diff options
| -rw-r--r-- | Documentation/devicetree/bindings/tty/serial/of-serial.txt | 3 | ||||
| -rw-r--r-- | drivers/tty/serial/of_serial.c | 17 |
2 files changed, 20 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/tty/serial/of-serial.txt b/Documentation/devicetree/bindings/tty/serial/of-serial.txt index 35e53ae85eec..337a7e51faca 100644 --- a/Documentation/devicetree/bindings/tty/serial/of-serial.txt +++ b/Documentation/devicetree/bindings/tty/serial/of-serial.txt @@ -19,6 +19,9 @@ Optional properties: - current-speed : the current active speed of the UART. - reg-offset : offset to apply to the mapbase from the start of the registers. - reg-shift : quantity to shift the register offsets by. +- reg-io-width : the size (in bytes) of the IO accesses that should be + performed on the device. There are some systems that require 32-bit + accesses to the UART (e.g. TI davinci). - used-by-rtas : set to indicate that the port is in use by the OpenFirmware RTAS and should not be registered. diff --git a/drivers/tty/serial/of_serial.c b/drivers/tty/serial/of_serial.c index c911b2419abb..36038ed8f09a 100644 --- a/drivers/tty/serial/of_serial.c +++ b/drivers/tty/serial/of_serial.c @@ -65,6 +65,23 @@ static int __devinit of_platform_serial_setup(struct platform_device *ofdev, port->irq = irq_of_parse_and_map(np, 0); port->iotype = UPIO_MEM; + prop = of_get_property(np, "reg-io-width", &prop_size); + if (prop && (prop_size == sizeof(u32))) { + switch (be32_to_cpup(prop)) { + case 1: + port->iotype = UPIO_MEM; + break; + case 4: + port->iotype = UPIO_MEM32; + break; + default: + dev_warn(&ofdev->dev, + "unsupported io width (%d bytes)\n", + be32_to_cpup(prop)); + return -EINVAL; + } + } + port->type = type; port->uartclk = be32_to_cpup(clk); port->flags = UPF_SHARE_IRQ | UPF_BOOT_AUTOCONF | UPF_IOREMAP |