scsi: ufs: qcom: Add support for scaling interconnects

Qcom SoCs require scaling the interconnect paths for proper working of the
peripherals connected through interconnects. Even for accessing the UFS
controller, someone should setup the interconnect paths. So far, the
bootloaders used to setup the interconnect paths before booting Linux as
they need to access the UFS storage for things like fetching boot firmware.
But with the advent of multi boot options, bootloader nowadays like in
SA8540p SoC do not setup the interconnect paths at all.

So trying to configure UFS in the absence of the interconnect path
configuration results in a boot crash.

To fix this issue, and also to dynamically scale the interconnects (UFS-DDR
and CPU-UFS), interconnect API support is added to the Qcom UFS driver.
With this support, the interconnect paths are scaled dynamically based on
the gear configuration.

During the early stage of ufs_qcom_init(), ufs_qcom_icc_init() will setup
the paths to max bandwidth to allow configuring the UFS registers. Touching
the registers without configuring the icc paths would result in a crash.
However, we don't really need to set max vote for the icc paths as any
minimal vote would suffice. But the max value would allow initialization to
be done faster. After init, the bandwidth will get updated using
ufs_qcom_icc_update_bw() based on the gear and lane configuration.

The bandwidth values defined in ufs_qcom_bw_table struct are taken from
Qcom downstream vendor devicetree source and are calculated as per the
UFS3.1 Spec, Section 6.4.1, HS Gear Rates. So it is fixed across platforms.

Cc: Brian Masney <bmasney@redhat.com>
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
Link: https://lore.kernel.org/r/20230731145020.41262-3-manivannan.sadhasivam@linaro.org
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>

0 files changed, 0 insertions, 0 deletions