diff options
Diffstat (limited to 'Documentation/devicetree/bindings/ata/ahci-platform.txt')
-rw-r--r-- | Documentation/devicetree/bindings/ata/ahci-platform.txt | 79 |
1 files changed, 0 insertions, 79 deletions
diff --git a/Documentation/devicetree/bindings/ata/ahci-platform.txt b/Documentation/devicetree/bindings/ata/ahci-platform.txt deleted file mode 100644 index 77091a277642..000000000000 --- a/Documentation/devicetree/bindings/ata/ahci-platform.txt +++ /dev/null @@ -1,79 +0,0 @@ -* AHCI SATA Controller - -SATA nodes are defined to describe on-chip Serial ATA controllers. -Each SATA controller should have its own node. - -It is possible, but not required, to represent each port as a sub-node. -It allows to enable each port independently when dealing with multiple -PHYs. - -Required properties: -- compatible : compatible string, one of: - - "brcm,iproc-ahci" - - "hisilicon,hisi-ahci" - - "cavium,octeon-7130-ahci" - - "ibm,476gtr-ahci" - - "marvell,armada-380-ahci" - - "marvell,armada-3700-ahci" - - "snps,dwc-ahci" - - "snps,spear-ahci" - - "generic-ahci" -- interrupts : <interrupt mapping for SATA IRQ> -- reg : <registers mapping> - -Please note that when using "generic-ahci" you must also specify a SoC specific -compatible: - compatible = "manufacturer,soc-model-ahci", "generic-ahci"; - -Optional properties: -- dma-coherent : Present if dma operations are coherent -- clocks : a list of phandle + clock specifier pairs -- resets : a list of phandle + reset specifier pairs -- target-supply : regulator for SATA target power -- phy-supply : regulator for PHY power -- phys : reference to the SATA PHY node -- phy-names : must be "sata-phy" -- ahci-supply : regulator for AHCI controller -- ports-implemented : Mask that indicates which ports that the HBA supports - are available for software to use. Useful if PORTS_IMPL - is not programmed by the BIOS, which is true with - some embedded SOC's. - -Required properties when using sub-nodes: -- #address-cells : number of cells to encode an address -- #size-cells : number of cells representing the size of an address - -Sub-nodes required properties: -- reg : the port number -And at least one of the following properties: -- phys : reference to the SATA PHY node -- target-supply : regulator for SATA target power - -Examples: - sata@ffe08000 { - compatible = "snps,spear-ahci"; - reg = <0xffe08000 0x1000>; - interrupts = <115>; - }; - -With sub-nodes: - sata@f7e90000 { - compatible = "marvell,berlin2q-achi", "generic-ahci"; - reg = <0xe90000 0x1000>; - interrupts = <GIC_SPI 7 IRQ_TYPE_LEVEL_HIGH>; - clocks = <&chip CLKID_SATA>; - #address-cells = <1>; - #size-cells = <0>; - - sata0: sata-port@0 { - reg = <0>; - phys = <&sata_phy 0>; - target-supply = <®_sata0>; - }; - - sata1: sata-port@1 { - reg = <1>; - phys = <&sata_phy 1>; - target-supply = <®_sata1>;; - }; - }; |