diff options
Diffstat (limited to 'include/linux/platform_data')
-rw-r--r-- | include/linux/platform_data/i2c-gpio.h | 34 | ||||
-rw-r--r-- | include/linux/platform_data/i2c-mux-gpio.h | 43 | ||||
-rw-r--r-- | include/linux/platform_data/i2c-ocores.h | 23 | ||||
-rw-r--r-- | include/linux/platform_data/i2c-omap.h | 39 | ||||
-rw-r--r-- | include/linux/platform_data/i2c-pca-platform.h | 10 | ||||
-rw-r--r-- | include/linux/platform_data/i2c-xiic.h | 43 |
6 files changed, 192 insertions, 0 deletions
diff --git a/include/linux/platform_data/i2c-gpio.h b/include/linux/platform_data/i2c-gpio.h new file mode 100644 index 000000000000..352c1426fd4d --- /dev/null +++ b/include/linux/platform_data/i2c-gpio.h @@ -0,0 +1,34 @@ +/* + * i2c-gpio interface to platform code + * + * Copyright (C) 2007 Atmel Corporation + * + * This program is free software; you can redistribute it and/or modify + * it under the terms of the GNU General Public License version 2 as + * published by the Free Software Foundation. + */ +#ifndef _LINUX_I2C_GPIO_H +#define _LINUX_I2C_GPIO_H + +/** + * struct i2c_gpio_platform_data - Platform-dependent data for i2c-gpio + * @udelay: signal toggle delay. SCL frequency is (500 / udelay) kHz + * @timeout: clock stretching timeout in jiffies. If the slave keeps + * SCL low for longer than this, the transfer will time out. + * @sda_is_open_drain: SDA is configured as open drain, i.e. the pin + * isn't actively driven high when setting the output value high. + * gpio_get_value() must return the actual pin state even if the + * pin is configured as an output. + * @scl_is_open_drain: SCL is set up as open drain. Same requirements + * as for sda_is_open_drain apply. + * @scl_is_output_only: SCL output drivers cannot be turned off. + */ +struct i2c_gpio_platform_data { + int udelay; + int timeout; + unsigned int sda_is_open_drain:1; + unsigned int scl_is_open_drain:1; + unsigned int scl_is_output_only:1; +}; + +#endif /* _LINUX_I2C_GPIO_H */ diff --git a/include/linux/platform_data/i2c-mux-gpio.h b/include/linux/platform_data/i2c-mux-gpio.h new file mode 100644 index 000000000000..4406108201fe --- /dev/null +++ b/include/linux/platform_data/i2c-mux-gpio.h @@ -0,0 +1,43 @@ +/* + * i2c-mux-gpio interface to platform code + * + * Peter Korsgaard <peter.korsgaard@barco.com> + * + * This program is free software; you can redistribute it and/or modify + * it under the terms of the GNU General Public License version 2 as + * published by the Free Software Foundation. + */ + +#ifndef _LINUX_I2C_MUX_GPIO_H +#define _LINUX_I2C_MUX_GPIO_H + +/* MUX has no specific idle mode */ +#define I2C_MUX_GPIO_NO_IDLE ((unsigned)-1) + +/** + * struct i2c_mux_gpio_platform_data - Platform-dependent data for i2c-mux-gpio + * @parent: Parent I2C bus adapter number + * @base_nr: Base I2C bus number to number adapters from or zero for dynamic + * @values: Array of bitmasks of GPIO settings (low/high) for each + * position + * @n_values: Number of multiplexer positions (busses to instantiate) + * @classes: Optional I2C auto-detection classes + * @gpio_chip: Optional GPIO chip name; if set, GPIO pin numbers are given + * relative to the base GPIO number of that chip + * @gpios: Array of GPIO numbers used to control MUX + * @n_gpios: Number of GPIOs used to control MUX + * @idle: Bitmask to write to MUX when idle or GPIO_I2CMUX_NO_IDLE if not used + */ +struct i2c_mux_gpio_platform_data { + int parent; + int base_nr; + const unsigned *values; + int n_values; + const unsigned *classes; + char *gpio_chip; + const unsigned *gpios; + int n_gpios; + unsigned idle; +}; + +#endif /* _LINUX_I2C_MUX_GPIO_H */ diff --git a/include/linux/platform_data/i2c-ocores.h b/include/linux/platform_data/i2c-ocores.h new file mode 100644 index 000000000000..01edd96fe1f7 --- /dev/null +++ b/include/linux/platform_data/i2c-ocores.h @@ -0,0 +1,23 @@ +/* + * i2c-ocores.h - definitions for the i2c-ocores interface + * + * Peter Korsgaard <jacmet@sunsite.dk> + * + * This file is licensed under the terms of the GNU General Public License + * version 2. This program is licensed "as is" without any warranty of any + * kind, whether express or implied. + */ + +#ifndef _LINUX_I2C_OCORES_H +#define _LINUX_I2C_OCORES_H + +struct ocores_i2c_platform_data { + u32 reg_shift; /* register offset shift value */ + u32 reg_io_width; /* register io read/write width */ + u32 clock_khz; /* input clock in kHz */ + bool big_endian; /* registers are big endian */ + u8 num_devices; /* number of devices in the devices list */ + struct i2c_board_info const *devices; /* devices connected to the bus */ +}; + +#endif /* _LINUX_I2C_OCORES_H */ diff --git a/include/linux/platform_data/i2c-omap.h b/include/linux/platform_data/i2c-omap.h new file mode 100644 index 000000000000..3444265ee8ee --- /dev/null +++ b/include/linux/platform_data/i2c-omap.h @@ -0,0 +1,39 @@ +/* SPDX-License-Identifier: GPL-2.0 */ +#ifndef __I2C_OMAP_H__ +#define __I2C_OMAP_H__ + +#include <linux/platform_device.h> + +/* + * Version 2 of the I2C peripheral unit has a different register + * layout and extra registers. The ID register in the V2 peripheral + * unit on the OMAP4430 reports the same ID as the V1 peripheral + * unit on the OMAP3530, so we must inform the driver which IP + * version we know it is running on from platform / cpu-specific + * code using these constants in the hwmod class definition. + */ + +#define OMAP_I2C_IP_VERSION_1 1 +#define OMAP_I2C_IP_VERSION_2 2 + +/* struct omap_i2c_bus_platform_data .flags meanings */ + +#define OMAP_I2C_FLAG_NO_FIFO BIT(0) +#define OMAP_I2C_FLAG_SIMPLE_CLOCK BIT(1) +#define OMAP_I2C_FLAG_16BIT_DATA_REG BIT(2) +#define OMAP_I2C_FLAG_ALWAYS_ARMXOR_CLK BIT(5) +#define OMAP_I2C_FLAG_FORCE_19200_INT_CLK BIT(6) +/* how the CPU address bus must be translated for I2C unit access */ +#define OMAP_I2C_FLAG_BUS_SHIFT_NONE 0 +#define OMAP_I2C_FLAG_BUS_SHIFT_1 BIT(7) +#define OMAP_I2C_FLAG_BUS_SHIFT_2 BIT(8) +#define OMAP_I2C_FLAG_BUS_SHIFT__SHIFT 7 + +struct omap_i2c_bus_platform_data { + u32 clkrate; + u32 rev; + u32 flags; + void (*set_mpu_wkup_lat)(struct device *dev, long set); +}; + +#endif diff --git a/include/linux/platform_data/i2c-pca-platform.h b/include/linux/platform_data/i2c-pca-platform.h new file mode 100644 index 000000000000..c37329432a8e --- /dev/null +++ b/include/linux/platform_data/i2c-pca-platform.h @@ -0,0 +1,10 @@ +/* SPDX-License-Identifier: GPL-2.0 */ +#ifndef I2C_PCA9564_PLATFORM_H +#define I2C_PCA9564_PLATFORM_H + +struct i2c_pca9564_pf_platform_data { + int i2c_clock_speed; /* values are defined in linux/i2c-algo-pca.h */ + int timeout; /* timeout in jiffies */ +}; + +#endif /* I2C_PCA9564_PLATFORM_H */ diff --git a/include/linux/platform_data/i2c-xiic.h b/include/linux/platform_data/i2c-xiic.h new file mode 100644 index 000000000000..4f9f2256a97e --- /dev/null +++ b/include/linux/platform_data/i2c-xiic.h @@ -0,0 +1,43 @@ +/* + * i2c-xiic.h + * Copyright (c) 2009 Intel Corporation + * + * This program is free software; you can redistribute it and/or modify + * it under the terms of the GNU General Public License version 2 as + * published by the Free Software Foundation. + * + * This program is distributed in the hope that it will be useful, + * but WITHOUT ANY WARRANTY; without even the implied warranty of + * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the + * GNU General Public License for more details. + * + * You should have received a copy of the GNU General Public License + * along with this program; if not, write to the Free Software + * Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA. + */ + +/* Supports: + * Xilinx IIC + */ + +#ifndef _LINUX_I2C_XIIC_H +#define _LINUX_I2C_XIIC_H + +/** + * struct xiic_i2c_platform_data - Platform data of the Xilinx I2C driver + * @num_devices: Number of devices that shall be added when the driver + * is probed. + * @devices: The actuall devices to add. + * + * This purpose of this platform data struct is to be able to provide a number + * of devices that should be added to the I2C bus. The reason is that sometimes + * the I2C board info is not enough, a new PCI board can for instance be + * plugged into a standard PC, and the bus number might be unknown at + * early init time. + */ +struct xiic_i2c_platform_data { + u8 num_devices; + struct i2c_board_info const *devices; +}; + +#endif /* _LINUX_I2C_XIIC_H */ |