usb: ehci: ehci-marvell: Support for marvell,ac5-ehci

Unlike the other 64-bit mvebu SoCs the AlleyCat5 uses the older ehci
block from the 32-bit SoCs. Adapt the ehci-marvell.c driver to cope with
the fact that the ac5 does not have the mbus infrastructure the 32-bit
SoCs have and ensure USB_EHCI_IS_TDI is selected.

Signed-off-by: Chris Packham <judge.packham@gmail.com>
Reviewed-by: Stefan Roese <sr@denx.de>

2 files changed, 46 insertions, 8 deletions

diff --git a/drivers/usb/host/Kconfig b/drivers/usb/host/Kconfig
index 4efdd708c2..6213b3c95f 100644
--- a/drivers/usb/host/Kconfig
+++ b/drivers/usb/host/Kconfig
@@ -178,6 +178,7 @@ config USB_EHCI_MARVELL
 	depends on ARCH_MVEBU || ARCH_KIRKWOOD || ARCH_ORION5X
 	default y
 	select USB_EHCI_IS_TDI if !ARM64
+	select USB_EHCI_IS_TDI if ALLEYCAT_5
 	---help---
 	  Enables support for the on-chip EHCI controller on MVEBU SoCs.
 
diff --git a/drivers/usb/host/ehci-marvell.c b/drivers/usb/host/ehci-marvell.c
index b7e60c690a..6093c8fb0b 100644
--- a/drivers/usb/host/ehci-marvell.c
+++ b/drivers/usb/host/ehci-marvell.c
@@ -48,12 +48,17 @@ struct ehci_mvebu_priv {
 	fdt_addr_t hcd_base;
 };
 
+#define USB_TO_DRAM_TARGET_ID 0x2
+#define USB_TO_DRAM_ATTR_ID 0x0
+#define USB_DRAM_BASE 0x00000000
+#define USB_DRAM_SIZE 0xfff	/* don't overrun u-boot source (was 0xffff) */
+
 /*
  * Once all the older Marvell SoC's (Orion, Kirkwood) are converted
  * to the common mvebu archticture including the mbus setup, this
  * will be the only function needed to configure the access windows
  */
-static void usb_brg_adrdec_setup(void *base)
+static void usb_brg_adrdec_setup(struct udevice *dev, void *base)
 {
 	const struct mbus_dram_target_info *dram;
 	int i;
@@ -65,16 +70,34 @@ static void usb_brg_adrdec_setup(void *base)
 		writel(0, base + USB_WINDOW_BASE(i));
 	}
 
-	for (i = 0; i < dram->num_cs; i++) {
-		const struct mbus_dram_window *cs = dram->cs + i;
+	if (device_is_compatible(dev, "marvell,ac5-ehci")) {
+		/*
+		 * use decoding window to map dram address seen by usb to 0x0
+		 */
 
 		/* Write size, attributes and target id to control register */
-		writel(((cs->size - 1) & 0xffff0000) | (cs->mbus_attr << 8) |
-		       (dram->mbus_dram_target_id << 4) | 1,
-		       base + USB_WINDOW_CTRL(i));
+		writel((USB_DRAM_SIZE << 16) | (USB_TO_DRAM_ATTR_ID << 8) |
+		       (USB_TO_DRAM_TARGET_ID << 4) | 1,
+		       base + USB_WINDOW_CTRL(0));
 
 		/* Write base address to base register */
-		writel(cs->base, base + USB_WINDOW_BASE(i));
+		writel(USB_DRAM_BASE, base + USB_WINDOW_BASE(0));
+
+		debug("## AC5 decoding windows, ctrl[%p]=0x%x, base[%p]=0x%x\n",
+		      base + USB_WINDOW_CTRL(0), readl(base + USB_WINDOW_CTRL(0)),
+		      base + USB_WINDOW_BASE(0), readl(base + USB_WINDOW_BASE(0)));
+	} else {
+		for (i = 0; i < dram->num_cs; i++) {
+			const struct mbus_dram_window *cs = dram->cs + i;
+
+			/* Write size, attributes and target id to control register */
+			writel(((cs->size - 1) & 0xffff0000) | (cs->mbus_attr << 8) |
+				   (dram->mbus_dram_target_id << 4) | 1,
+				   base + USB_WINDOW_CTRL(i));
+
+			/* Write base address to base register */
+			writel(cs->base, base + USB_WINDOW_BASE(i));
+		}
 	}
 }
 
@@ -126,7 +149,7 @@ static int ehci_mvebu_probe(struct udevice *dev)
 	if (device_is_compatible(dev, "marvell,armada-3700-ehci"))
 		marvell_ehci_ops.powerup_fixup = marvell_ehci_powerup_fixup;
 	else
-		usb_brg_adrdec_setup((void *)priv->hcd_base);
+		usb_brg_adrdec_setup(dev, (void *)priv->hcd_base);
 
 	hccr = (struct ehci_hccr *)(priv->hcd_base + 0x100);
 	hcor = (struct ehci_hcor *)
@@ -136,6 +159,19 @@ static int ehci_mvebu_probe(struct udevice *dev)
 	      (uintptr_t)hccr, (uintptr_t)hcor,
 	      (uintptr_t)HC_LENGTH(ehci_readl(&hccr->cr_capbase)));
 
+#define PHY_CALIB_OFFSET 0x808
+	/*
+	 * Trigger calibration during each usb start/reset:
+	 * BIT 13 to 0, and then to 1
+	 */
+	if (device_is_compatible(dev, "marvell,ac5-ehci")) {
+		void *phy_calib_reg = (void *)(priv->hcd_base + PHY_CALIB_OFFSET);
+		u32 val = readl(phy_calib_reg) & (~BIT(13));
+
+		writel(val, phy_calib_reg);
+		writel(val | BIT(13), phy_calib_reg);
+	}
+
 	return ehci_register(dev, hccr, hcor, &marvell_ehci_ops, 0,
 			     USB_INIT_HOST);
 }
@@ -143,6 +179,7 @@ static int ehci_mvebu_probe(struct udevice *dev)
 static const struct udevice_id ehci_usb_ids[] = {
 	{ .compatible = "marvell,orion-ehci", },
 	{ .compatible = "marvell,armada-3700-ehci", },
+	{ .compatible = "marvell,ac5-ehci", },
 	{ }
 };